 Heater fan autopsy, soldering next? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| anderssj |
 Apr 26 2005, 07:47 PM
Post
#1
|
|
Dog is my copilot...  Group: Members Posts: 1,664 Joined: 28-January 03 From: VA Member No.: 207 Region Association: MidAtlantic Region 
 |
Had a couple of hours between honey-do's so I was able to take apart the heater fan motor to see why it quit. Looks like the leads "unsoldered" themselves from the brush holders. I checked the resistance across the brushes and got about 2.5 - 3 ohms. I'm hoping that means that the windings are still OK.
Here's what it looked like (arrow points to where the solder left the work environment): Attached image(s) 
|
   |
 
|
Posts in this topic
anderssj Heater fan autopsy Apr 26 2005, 07:47 PM
anderssj Here's the other side: Apr 26 2005, 07:48 PM anderssj I also cleaned up the housing to make sure there w... Apr 26 2005, 07:51 PM anderssj So, I guess it's time to try out my soldering ... Apr 26 2005, 07:55 PM bd1308 make sure BOTH areas are very warm...no cold joint... Apr 26 2005, 08:02 PM anderssj Yeah, I'll need to practice . . . I figure it... Apr 26 2005, 08:05 PM 914GT I'm sure you know to use flux-core solder, not... Apr 26 2005, 09:16 PM anderssj Thanks! I'll probably try to fix it this ... Apr 27 2005, 07:23 AM Bleyseng make sure there isn't too much slop in the bea... Apr 27 2005, 07:32 AM anderssj Sorry, posted wrong...should have gone to Archie... Feb 21 2021, 04:56 PM
914werke @archie Feb 21 2021, 05:40 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th June 2024 - 11:21 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.