 Oil Pressure Gauge Help, Six Conversion |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| mmascari |
 Mar 4 2018, 12:55 PM
Post
#1
|
|
Member  Group: Members Posts: 321 Joined: 1-September 14 From: Concord, CA Member No.: 17,850 Region Association: None  |
I am troubleshooting a problem with the oil pressure gauge in my six conversion. It is a 3.0l engine. Since startup of the engine, once the gauge was connected to the sending unit the needle just pegs to the top. See picture. We changed out the sending unit. We also tested the actual pressure with a manual gauge and the pressure is good in the engine. Maybe the gauge is bad? Should I take it over to Palo Alto Speedo for testing?
Is it possible to test the gauge myself, if so, how? Thanks. By the way, I do have the correct sending unit for the specific gauge. Attached thumbnail(s) 
|
   |
 
|
Posts in this topic
mmascari Oil Pressure Gauge Help Mar 4 2018, 12:55 PM
Dave_Darling I believe the stock sender is a variable resistor.... Mar 4 2018, 02:11 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st June 2024 - 10:04 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.