 distributor question |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Marlow |
 Jun 3 2005, 06:08 PM
Post
#1
|
|
Member  Group: Members Posts: 311 Joined: 14-August 03 From: Manassas, VA Member No.: 1,027  |
I was cleaning up my distributor and saw two strange copper blobs on the distributor plates. Is there supposed to be a wire braid where the red line is in? If there is supposed to be a braid there what have you used to replace it? Desoldering wick and solder it in place?
Attached image(s) 
|
   |
 
|
Posts in this topic
porsche914blue distributor question Jun 3 2005, 06:08 PM
SirAndy can't help 'ya, but this question deserves... Jun 3 2005, 11:15 PM porsche914blue Thanks Andy, I'm surprised no one's answer... Jun 3 2005, 11:52 PM Joe Sharp I belive it is to make sure that the conection is ... Jun 4 2005, 01:18 AM bd1308 i'm surprised nobody answered this either. Yep... Jun 4 2005, 05:38 AM porsche914blue Thanks for the answers guys.
bd1308 - I never had... Jun 4 2005, 10:04 AM Bleyseng yep, its the grounding strap location. Since you a... Jun 4 2005, 12:03 PM porsche914blue Some up and down slop but tight side to side.
I... Jun 6 2005, 07:58 AM Cap'n Krusty If you don't have an ignition problem with the... Jun 6 2005, 08:39 AM
porsche914blue No previous ignition problems without the ground w... Jun 6 2005, 09:23 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st June 2024 - 10:30 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.