 Front bumper fitting |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| JFG |
 Jul 16 2018, 01:33 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 686 Joined: 7-April 16 From: Wales Member No.: 19,869 Region Association: None  |
I put 914 rubber front bumper top on my bumper tonight and fitted it for the first time.
There are 2 solid bumper blocks and 2 figure of 8's. The 2 solid blocks seem to be narrow one end and wider the other. Is this correct or have they crushed? I assume they fit with the narrow end to the top of the bumper? Problem I have is that the passenger side of the bumper sticks out further than the driver's side. The gap runs from the headlight bucket to the middle of the frunk. Any ideas? The bumper top fits much much better than I was expecting too. Nice one Mark. |
   |
 
|
Posts in this topic
JFG Front bumper fitting Jul 16 2018, 01:33 PM
Philip W. I am new to these but just fitted one on mine and ... Jul 16 2018, 01:52 PM JFG It would appear that the bumper is bent. This wasn... Jul 17 2018, 11:41 AM Mikey914 It may be easier to relieve a little bit of the ru... Jul 17 2018, 02:27 PM Philip W. this bumper is a bit rough, faded chrome and dents... Jul 17 2018, 02:33 PM mepstein Using studs instead of bolts makes it a lot easier... Jul 17 2018, 02:34 PM
Philip W.
Using studs instead of bolts makes it a lot easie... Jul 17 2018, 02:36 PM mepstein
Using studs instead of bolts makes it a lot easi... Jul 17 2018, 02:43 PM malcolm2
Using studs instead of bolts makes it a lot easi... Jul 18 2018, 06:56 AM JFG From inspection i think this bumper may have bumpe... Jul 18 2018, 04:50 AM Philip W.
From inspection i think this bumper may have bump... Jul 18 2018, 05:49 AM JFG Will bear the above in mind for the next project.
... Jul 18 2018, 07:21 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 3rd June 2024 - 10:07 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.