I beams as a 914 lift for engine removal |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
I beams as a 914 lift for engine removal |
daveholiday |
Feb 6 2019, 06:01 PM
Post
#1
|
Newbie Group: Members Posts: 12 Joined: 15-March 15 From: Augusta, GA Member No.: 18,521 Region Association: South East States |
I have jumped back into my 914 revival project. I am looking at another engine/trans removal and wanted to get an opinion about a "proposed" project. I have enough room in my garage to to install a couple "I-beams" to roll the car up on to remove the engine. According to my measurements....20" is the basic height of the engine/transmission. So if I have two 18" tall I-beams I should have roughly 24" of clearance under the car to slide the whole mess out....right? Any thoughts or feedback on the I-beam setup?
|
Lo-Fi Version | Time is now: 15th June 2024 - 04:18 PM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |