 New key is thiiiiiis close. |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| FlacaProductions |
 Jun 5 2019, 09:34 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,615 Joined: 24-November 17 From: LA Member No.: 21,628 Region Association: Southern California 
 |
I had a new key cut and it seems that it's juuuust a bit "off" - it works fine in one orientation (both in the doors and in the ignition) but if you flip it over, it won't turn - easily, anyway. You can wiggle it around and gently put a little pull on it and it MIGHT turn.
I had a door lock cylinder out at the time and noticed that it doesn't quite suck in the wafers to the point where they are flush with the cylinder. Does this mean the key was cut too far/deep or not far enough? I'm wondering if a little gentle overall filing/smoothing might help but not sure which side to do since it turns one way, but not the other... |
   |
 
|
Posts in this topic
FlacaProductions New key is thiiiiiis close. Jun 5 2019, 09:34 AM
Carl La Fong
I had a new key cut and it seems that it's ju... Jun 5 2019, 10:25 AM
theer The answer to your question.... it depends. Take ... Jun 5 2019, 07:27 PM FlacaProductions Ahhh - ok. That's interesting. I had the dri... Jun 5 2019, 07:44 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 7th June 2024 - 09:44 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.