 Upside-down for Welding Floor? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| bkrantz |
 Jan 31 2020, 10:01 PM
Post
#1
|
|
914 Guru  Group: Members Posts: 8,360 Joined: 3-August 19 From: SW Colorado Member No.: 23,343 Region Association: Rocky Mountains 
 |
I am almost ready to attach my new rear half floor panel. With the car on a rotisserie, I can rotate to any position. My intuition tells me to position the car upside down, so that any flex will tend to "open" the door frames, and do it equally. With the car sideways, any flex will be asymmetrical. I do have door and diagonal braces welded in.
Any suggestions? Am I being paranoid? |
   |
 
|
Posts in this topic
bkrantz Upside-down for Welding Floor? Jan 31 2020, 10:01 PM
amfab
I am almost ready to attach my new rear half floo... Jan 31 2020, 10:18 PM
SirAndy stay paranoid
:agree: :D Jan 31 2020, 10:34 PM tygaboy I'm president of the local chapter of Paranoid... Jan 31 2020, 11:33 PM bbrock
I'm president of the local chapter of Paranoi... Jan 31 2020, 11:56 PM jmitro
I'm president of the local chapter of Paranoi... Feb 1 2020, 07:03 AM 914forme If you are using a overlap joint make sure the joi... Feb 1 2020, 08:34 AM bkrantz Thanks, everyone. Glad there are some others the ... Feb 1 2020, 10:40 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 01:10 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.