 All The Way In?, Push Rod Tube Refurb and New Seals with the Engine In |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| ctc911ctc |
 Mar 9 2020, 08:00 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 893 Joined: 9-June 18 From: boston Member No.: 22,206 Region Association: North East States 
 |
All,
'74, 2.0, stock Read all there is on this within the board. Got the Vitrons - Check, Tubes in good shape - replaced one - Thank 914Rubber. Was obsessive in cleaning the seal guides and seats lightly oiled the seals and guides They are in, are they in far enough? Too far? What do you think?  All four can be seen here (head side)  Here are the back two  And the front two Do they look seated correctly? In all of the way? As can also be seen is the damage to the cable coating when there is an exhaust leak - which started this job! |
   |
 
|
Posts in this topic
ctc911ctc All The Way In? Mar 9 2020, 08:00 PM
BeatNavy You can generally feel when it seats. It should g... Mar 9 2020, 08:18 PM cary Like Rob, I'd say they aren't in all the w... Mar 9 2020, 08:24 PM bobboinski I recently did this for the first time. Quite a bi... Mar 9 2020, 08:29 PM Specracer I am mid process doing this exact thing. I have th... Mar 10 2020, 03:38 AM TheCabinetmaker Beat navy said it right! Use a pair of channel... Mar 10 2020, 04:21 AM 914Sixer I prefer to used a deep socket (14 or 15 MM) on a ... Mar 10 2020, 06:15 AM ctc911ctc Thank you for all of the guidance!
I pushed t... Mar 10 2020, 07:17 AM Bleyseng Boy, I'd run a die over those rusty head studs... Mar 10 2020, 07:53 AM
ctc911ctc On it, buying the die today as a matter of fact... Mar 10 2020, 08:08 AM IronHillRestorations The procedure I've used the last few times is ... Mar 10 2020, 07:57 AM ctc911ctc Love your stuff, been following you and your compa... Mar 10 2020, 08:11 AM Mark Henry
It's mostly about making sure the bores don... Mar 10 2020, 06:25 PM Mikey914 The seals look too big. We didn't send you tho... Mar 11 2020, 01:18 AM ctc911ctc Mike,
I bought these from another vendor - i did ... Mar 11 2020, 06:32 AM ctc911ctc ****Update****
I removed the other side last nigh... Mar 11 2020, 06:56 AM Mikey914 I have found the difference between the off the sh... Mar 11 2020, 09:44 AM IronHillRestorations The old PRT seals had a fluted profile, very sligh... Mar 11 2020, 11:38 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 29th May 2024 - 12:05 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.