 Stock 914 CV Geometry, 914 Mid engine sandrail project |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| GGerg1186 |
 Dec 7 2020, 09:10 PM
Post
#1
|
|
Newbie  Group: Members Posts: 15 Joined: 28-September 20 From: Dubuque IA Member No.: 24,724 Region Association: Upper MidWest  |
Does anyone have general dimensions for max distance between the outer CV faces at zero, plus twelve, minus twelve degree angles?
I read that the stock 914 CV's are basically the same as a VW type 1, and on blind chicken racing the max angle is 12 degrees.  I have to build custom trailing arms for my sandrail project and need to develop the 3D suspension travel geometry that ensures I do not exceed the CV capacity throughout the range of motion.  If I have to I will just physically measure the parts, but it would be helpful if anyone who has already found this information could share. Yes, I am aware the 3D geometry along with camber, toe, etc needs to be calculated, but these general dimensions will get me 99% of the way there. Thanks |
   |
 
|
Posts in this topic
GGerg1186 Stock 914 CV Geometry Dec 7 2020, 09:10 PM
Bleyseng I think guys are using 930cv’s for more angle an... Dec 9 2020, 01:11 PM
Mike Bellis Swap over to 930 CV's or you are asking for tr... Dec 10 2020, 08:49 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 01:12 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.