 944 & VW Bus CV's, Thickness Difference |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| 914Sixer |
 Dec 14 2020, 04:03 PM
Post
#1
|
|
914 Guru  Group: Members Posts: 8,903 Joined: 17-January 05 From: San Angelo Texas Member No.: 3,457 Region Association: Southwest Region 
 |
Just thought I would pass this along. Today I was checking on the CV joints I was going to use on the full floating axles. I am using 911SC hubs, stub axles and 915 transmission flanges. The whole set up is 100mm 6 bolt. 944 CV conversion is over in the classic section. So, I got the joints out to compare, both are Lobro and have the same part number BUT they are different thickness. The LATE 944 are 34mm thick and the OLD (1978) Bus CV's are 32. Make sure all 4 of your CV's are the same thickness IF you are cutting your stock axles to to 944 conversion. NO problem if you are using floating axles.
|
   |
 
|
Posts in this topic
914Sixer 944 & VW Bus CV's Dec 14 2020, 04:03 PM
MM1 Thanks for sharing, Mark. Dec 14 2020, 04:50 PM
914Sixer Added chart from Blind Chicken Racing CV 101 for a... Dec 14 2020, 09:01 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 8th June 2024 - 09:19 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.