 Snap, crackle and pop!, engine problems |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Petepat |
 Dec 23 2022, 07:07 AM
Post
#1
|
|
Member  Group: Members Posts: 60 Joined: 1-December 19 From: Florida Member No.: 23,691 Region Association: None  |
So I have a 1.8L engine with twin carbs and its very difficult to start, if I put my foot on the gas too soon it just dies, I have to let it run at 2-3 hundred revs until it warms up and slowly cox it into life.It back fires a lot when I take my foot off the gas but often backfires with normal driving. I had the rockers (that's the English word!) checked for gap clearance and there was no gap on any of them!!? but it doesn't seemed to make much difference. Any thing that will stop me snapping, cracking up or popping will be gratefully received. I'm a newbe in the 914 world.
|
   |
 
|
Posts in this topic
Petepat Snap, crackle and pop! Dec 23 2022, 07:07 AM
Front yard mechanic
So I have a 1.8L engine with twin carbs and its v... Dec 23 2022, 08:54 AM
CCE
So I have a 1.8L engine with twin carbs and its ... Dec 30 2022, 01:25 PM Petepat
[quote name='Front yard mechanic' post='3046983' ... Jan 8 2023, 07:36 AM brant Timing also Dec 23 2022, 09:05 AM ChrisFoley Get a (Weber or Dellorto) book or look online for ... Dec 23 2022, 09:16 AM brant Also pay attention and look at the linkage careful... Dec 23 2022, 09:51 AM Craigers17 The folks that have responded know a lot more abou... Dec 23 2022, 09:52 AM rhodyguy How big are the carbs? 44s? 40s? Other? 44s with 3... Dec 23 2022, 10:36 AM 930cabman :wttc:
Did this condition just arise? It could b... Dec 23 2022, 10:38 AM Petepat
:wttc:
Did this condition just arise? It could ... Dec 30 2022, 06:20 AM ChrisFoley Its most important that all 4 are equal.
However,... Jan 8 2023, 08:39 AM Petepat
Its most important that all 4 are equal.
However... Jan 9 2023, 06:21 AM rhodyguy Use one idle speed screw to raise the idle to a po... Jan 9 2023, 08:40 AM Petepat So there is a number stamped on the carbs 3024, do... Jan 12 2023, 03:27 PM ChrisFoley Air flow correction jets are located at the base o... Jan 13 2023, 04:32 AM rhodyguy AFCJ=Air bypass screws in the CB manual. They are ... Jan 13 2023, 08:27 AM Petepat
AFCJ=Air bypass screws in the CB manual. They are... Jan 14 2023, 06:30 AM ChrisFoley The Delorto Superformance Tech Book, by Bob Tomlin... Jan 14 2023, 01:51 PM Petepat
The Delorto Superformance Tech Book, by Bob Tomli... Jan 15 2023, 06:55 AM ChrisFoley thought you were in Florida, lol Jan 14 2023, 01:51 PM Superhawk996 Get the Weber book.
Webers and Dellorto are nea... Jan 15 2023, 07:21 AM Petepat
Get the Weber book.
Webers and Dellorto are ne... Jan 16 2023, 04:54 AM ChrisFoley
Thanks for that, I have ordered the book and any... Jan 16 2023, 05:06 AM Petepat
Thanks for that, I have ordered the book and an... Jan 17 2023, 04:25 AM Petepat So, the Webber book is on it's way but in the ... Jan 19 2023, 04:36 AM Petepat I'm thinking to replace the lot, put the pump ... Jan 19 2023, 04:42 AM ChrisFoley I offer a complete pump and lines kit for carbed c... Jan 19 2023, 04:51 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 4th June 2024 - 11:57 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.