 Boat and Trumpet Install on IDTP Carbs, Special Tool Required? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| DennisV |
  Aug 14 2026, 07:18 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 993 Joined: 8-August 20 From: Santa Rosa, CA Member No.: 24,575 Region Association: Northern California 
 |
I am assembly IDTP carburetors. I have trumpets (aka velocity stacks) and also boats (bottom air cleaner connecting piece). Are they both meant to be used at the same time?
If so, how do you tighten the nut (8mm ATF)? I don't see room to get any conventional wrench or socket on there. Is there a special tool required? I'm probably missing something obvious. Top is what I understand to the be stacking order. Below an example of where the nuts need to go.   |
   |
 
|
Posts in this topic
DennisV Boat and Trumpet Install on IDTP Carbs Aug 14 2026, 07:18 AM
mskala For me, I got an 8mm deep socket (1/4" drive)... Aug 14 2026, 07:27 AM  |
4 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
2 Members: ndfrigi, Jack Standz
|
Lo-Fi Version | Time is now: 14th August 2026 - 09:58 AM |
Invision Power Board
v9.1.4 © 2026 IPS, Inc.