Home  |  Forums  |  914 Info  |  Blogs
 
914World.com - The fastest growing online 914 community!
 
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.
 

Welcome Guest ( Log In | Register )

> trans nut torque values and acceptable, distance from tob arm to rear of opening
rhodyguy
post Sep 21 2005, 12:24 PM
Post #1


Chimp Sanctuary NW. Check it out.
***************

Group: Members
Posts: 22,098
Joined: 2-March 03
From: Orion's Bell. The BELL!
Member No.: 378
Region Association: Galt's Gulch



on the gettin' together this am. can't find the torque values for mating the trans to the engine in Painyes. also, the minimum safe distance from the rear side of the throw out bearing arm, to the back of the opening on the trans that it comes out of. if i need to shim the pivot, i want to do it now. not after i have the powerplant installed and find i don't have enough clutch.

k
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Posts in this topic
rhodyguy   trans nut torque values and acceptable   Sep 21 2005, 12:24 PM
goose2   Kevin...trans torque is "guttentite"

Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 

- Lo-Fi Version Time is now: 15th June 2024 - 12:00 PM