 I can BARELY get into 1st., spot weld? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| meares |
 Oct 21 2005, 12:40 PM
Post
#1
|
|
Member  Group: Members Posts: 403 Joined: 23-March 05 From: Atlanta Member No.: 3,800  |
my shifter has just taken a sh#t! (IMG:http://www.914world.com/bbs2/html/emoticons/mad.gif) i can barely get into 1st or rev... i'll try to slam it in (which is the only way) 1st gear and it goes into 3rd....i'll immediately try it again and it'll go right into 1st????? (IMG:http://www.914world.com/bbs2/html/emoticons/headbang.gif) the shifter is VERY vague....i can go into 2 and 4 from the same (neutral, in the middle)spot with just a little (and i mean VERY little) movement to the left for 2nd same thing for 3rd and 5th......it's a side shifter and ALL bushings are new....got them from PP....any ideas??? THANKS (IMG:http://www.914world.com/bbs2/html/emoticons/beerchug.gif)
|
   |
 
|
Posts in this topic
meares I can BARELY get into 1st. Oct 21 2005, 12:40 PM
JmuRiz Typically when my car won't go easily into 1st... Oct 21 2005, 12:42 PM meares but it is ALL gears...almost like a shifter adjust... Oct 21 2005, 12:44 PM Aaron Cox Oct 21 2005, 12:46 PM meares where is the cone screw and is the adj. a pain to ... Oct 21 2005, 12:54 PM SLITS Oct 21 2005, 01:36 PM Andyrew Check your firewall bushing.
Betcha thats popped ... Oct 21 2005, 01:40 PM SGB the "cone screws" are just conical set screws- one... Oct 21 2005, 01:43 PM Cano http://www.914world.com/bbs2/h... Oct 21 2005, 02:10 PM lapuwali Interestingly, I found that with a new cup bushing... Oct 21 2005, 02:36 PM bd1308 hey....
it's the cone screw.....
mine did it... Oct 21 2005, 02:43 PM Red-Beard After you are done "screwing" around, also get the... Oct 22 2005, 06:19 AM Cap'n Krusty The springs? Why? They don't wear out. The ... Oct 22 2005, 07:50 AM lylegd My vote would be that one of your cone screws has ... Oct 22 2005, 09:03 AM
meares it was the cone screw on the shift rod next to the... Oct 24 2005, 07:14 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 31st May 2024 - 10:49 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.