 Plastigauge mains?, how to? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| goose2 |
 Feb 13 2006, 05:33 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 976 Joined: 30-March 05 From: Eugene, Oregon Member No.: 3,847 Region Association: Pacific Northwest  |
I'd like to do a dry run on my lower end assembly to check main bearing clearances with Plastigauge. I assume I can just bolt it up and torque it down using only the main bearing saddle bolts, with no sealant, to get a reading. It's a 3.0 six. Is this correct?
Thanks, Randy |
   |
 
|
Posts in this topic
goose2 Plastigauge mains? Feb 13 2006, 05:33 PM
Cap'n Krusty Case been align bored? Crank been turned? Measur... Feb 13 2006, 05:44 PM goose2 Thanks for the reply. Everything measures good Cap... Feb 13 2006, 11:49 PM Jake Raby Plasticgage is near impossible to use on mains....... Feb 14 2006, 08:34 AM Joe Ricard Hey that's cool tid bit of info.
Jake are you ... Feb 14 2006, 10:10 AM Jake Raby I'm pretty much caught up now... magazine guy... Feb 14 2006, 10:51 AM type47 Feb 14 2006, 12:57 PM Jake Raby Feb 14 2006, 01:06 PM LvSteveH With regard to the plastiguage issue, some of the ... Feb 14 2006, 01:22 PM goose2 Thanks for all the good advice. I've built per... Feb 14 2006, 01:58 PM Jake Raby I would like to add that the specs I gave were for... Feb 14 2006, 05:20 PM
Mark Henry I've only ever used it once in 20 years of bui... Feb 14 2006, 05:24 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 16th June 2024 - 04:18 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.