 buggered up the qt panel a while back, dent |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| bd1308 |
 Nov 5 2006, 01:21 AM
Post
#1
|
|
Sir Post-a-lot  Group: Members Posts: 8,020 Joined: 24-January 05 From: Louisville,KY Member No.: 3,501  |
kidna hard to explain, a combo of a floor jack and not good chocks and soft asphalt during summer caused the car to fall off the jack and onto the tire/rotor as i was putting tire on car.
I'm ok, but the car's fender is pushed up and out a tad. peen hammers, or a section from a donor? |
   |
 
|
Posts in this topic
bd1308 buggered up the qt panel a while back Nov 5 2006, 01:21 AM
So.Cal.914 Could you post a few pic's? Nov 5 2006, 01:41 AM bd1308 If I get a chance I will. Nov 5 2006, 01:44 AM jsteele22 Just tagging along with this one - I've got a ... Nov 5 2006, 01:14 PM So.Cal.914 If you can opperate a drill a saw a grinder and yo... Nov 5 2006, 01:43 PM bd1308 well this guy has a stud welder, and a puller for ... Nov 5 2006, 02:34 PM thewheel69 I'm tagging this thread too... same issue with... Nov 5 2006, 02:43 PM bd1308 Give me a week, I'll pull it and let you know ... Nov 5 2006, 02:44 PM
bd1308 I welded my car back together again (massive hell ... Nov 5 2006, 02:45 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 8th June 2024 - 10:44 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.