 Guess the failure |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| 1bad914 |
 May 13 2007, 06:15 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 618 Joined: 6-May 04 From: Battle Creek, MI Member No.: 2,028  |
Based on the pictures can you guess what failed on this brand new motor with less than 45 minutes running time???
Attached image(s)  
|
   |
 
|
Posts in this topic
1bad914 Guess the failure May 13 2007, 06:15 PM
So.Cal.914 BUMMER. May 13 2007, 06:18 PM type47 the positioning pin that locates the bearing so th... May 13 2007, 06:21 PM Matt Romanowski Who bought the bearings with double pin holes? Bum... May 13 2007, 06:21 PM 1bad914 Good guess, but the pins were right, they were pou... May 13 2007, 06:24 PM type47 if it started to spin the bearings, would that mea... May 13 2007, 06:28 PM bondo I'm going to guess oil pump failure. May 13 2007, 06:29 PM 1bad914 Case was fine, miked it all, it had never been ali... May 13 2007, 06:32 PM 1bad914 BINGO!!! Oil pump let me down, not rea... May 13 2007, 06:38 PM type47 what's the wisdom on re-using oil pumps (stock... May 13 2007, 06:45 PM 1bad914 I usually do not take a chance on using a used one... May 13 2007, 06:48 PM john rogers That is really painful to see! We used to have... May 13 2007, 06:55 PM bondo Yikes. Shouldn't you have seen the lack of oil... May 13 2007, 07:05 PM scotty b I assume you packed it with jelly ?? I forgot it o... May 13 2007, 07:17 PM Paul Illick My guess too, that the pump cavitated. May 13 2007, 07:43 PM Jake Raby The Type 1 pumps can't really fail unless they... May 13 2007, 08:09 PM McMark Oil pumps can be finicky for the first pressurizat... May 13 2007, 08:16 PM Jake Raby BTW- IF the oil pressure relief hangs open there w... May 13 2007, 08:30 PM 1bad914 Yes I primed the motor until the oil light went ou... May 13 2007, 08:37 PM 1bad914 I was banging around on the number three, it was i... May 13 2007, 08:48 PM
Jake Raby An engine should NEVER be hard to spin when new... May 13 2007, 08:53 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 5th June 2024 - 01:11 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.