 Cleaning Up Fresh Air Ventilation Box, Removing the circular clips |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| andys |
 Oct 10 2007, 12:47 PM
Post
#1
|
|
Advanced Member  Group: Members Posts: 2,165 Joined: 21-May 03 From: Valencia, CA Member No.: 721 Region Association: None 
 |
I'm cleaning up my fresh air ventilation box (under the cowl), and want to disassemble the housing that holds the fan and motor. There are some circular steel wire clips that hold the plastic housing halves together. What is the best tool or method to remove, and then replace them without cracking the plastic bosses?
Also, it looks like the foam rubber on the butterfly valves are about shot. Where can I get suitable replacements or the material to repair them? Recommendations? Thanks, Andys |
   |
 
|
Posts in this topic
andys Cleaning Up Fresh Air Ventilation Box Oct 10 2007, 12:47 PM
914Sixer I used a small screwdriver turned sideways to gent... Oct 10 2007, 12:51 PM Headrage I just slid the clips along the channel and off th... Oct 10 2007, 01:11 PM
andys
I just slid the clips along the channel and off t... Oct 10 2007, 01:26 PM Garold Shaffer Those clips can be a PITA. The hard part for wasn... Oct 11 2007, 08:34 AM drken Just went through this. I found what worked best ... Dec 7 2010, 09:45 PM McMark Ken, you're right for the 'rectangular... Dec 7 2010, 10:28 PM realred914 neoprene rubber works nice for the seals on the va... Dec 8 2010, 10:22 AM Mikey914 The one thing you should realy do is check the mot... Dec 9 2010, 01:17 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 16th June 2024 - 09:33 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.