 Drilling intermediate plate for bellcrank post, how deep can I go? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| thesey914 |
 Nov 15 2007, 04:34 PM
Post
#1
|
|
Senior Member  Group: Benefactors Posts: 1,155 Joined: 1-January 03 From: Staffordshire -England Member No.: 66   |
How deep can I go? There looks like there is a pressed in plug where I need to drill, can this be extracted? My trans is a tailshift (think the inter-plates are the same anyway)
I'm planning to make the post out of a piece of silversteel and press it in -did the factory do this or thread the post on the 914-6? |
   |
 
|
Posts in this topic
thesey914 Drilling intermediate plate for bellcrank post Nov 15 2007, 04:34 PM
davep The post is threaded 8mm x 1.25, threaded section ... Nov 15 2007, 04:39 PM dr914@autoatlanta.com
How deep can I go? There looks like there is a pr... Nov 15 2007, 04:44 PM Dr Evil The hole goes as deep as the perpendicular hole fo... Nov 15 2007, 08:32 PM thesey914 Thanks for the reply's (couldn't have aske... Nov 16 2007, 10:16 AM Cap'n Krusty What is "silversteel"? The Cap'n Nov 16 2007, 11:05 AM sixnotfour cold roll Nov 16 2007, 11:11 AM davep From your photo it may be a plug. You would have t... Nov 16 2007, 11:20 AM
thesey914 Silversteel is sometimes called bright steel, basi... Nov 16 2007, 03:46 PM  |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th June 2024 - 09:31 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.