 Cylinder Head temp sensor, question on spark plug sensor |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Joe Owensby |
 May 8 2008, 09:43 PM
Post
#1
|
|
JoeO  Group: Members Posts: 527 Joined: 7-January 06 From: Spartanburg, SC Member No.: 5,385 Region Association: South East States  |
I have one of the Dakota Digital CHT sensors. Works great by the way. However, I have a question on the sensor that goes beneath the spark plug. Do these normally get distorted? See photo below. Using this on a set of heads from a Raby kit, with the smaller spark plugs. The sensor fit reasonably well on the plug, but it is now distorted from clamping down on the head. Thanks, JoeO
Attached image(s) 
|
   |
 
|
Posts in this topic
Joe Owensby Cylinder Head temp sensor May 8 2008, 09:43 PM
SGB Seems like it would not seal right. Is the openin... May 8 2008, 10:02 PM Joe Mama I put mine under the plug and then slip the washer... May 8 2008, 10:29 PM type47 mine got distorted/bent up when i installed it und... May 9 2008, 08:34 AM HAM Inc Yes, you'll need the 12mm thermocouple. That i... May 9 2008, 08:42 AM toon1 Same thing happened to me. I made one out of a pie... May 9 2008, 08:57 AM purple i would take the sealing washer off the plug if yo... May 9 2008, 11:24 AM
Joe Owensby Thanks everyone for the suggestions. I will get ... May 9 2008, 11:21 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd June 2024 - 11:10 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.