Home  |  Forums  |  914 Info  |  Blogs
 
914World.com - The fastest growing online 914 community!
 
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.
 

Welcome Guest ( Log In | Register )

> removing oil pump
dmenche914
post Feb 20 2004, 04:31 PM
Post #1


Senior Member
***

Group: Members
Posts: 1,212
Joined: 27-February 03
From: California
Member No.: 366
i got some good replies to my prior question about how to best remove the oil pump (engine out of car) I am not rebuilding the engine now, just want to check the pump as pressure was a tad bit low when hot.

It was suggested that I might have to loosen the case half bolts to get the pump out.

Will I run into problems with case half leaks if I need to do this?

Isn't the case halves sealed with "glue" to prevent leaks, and if I seperate the halves even slightly, I would need to re-apply sealant?

How can I reapply sealant to the halves If I do not fully split them, and clean them up? Remember, I am only pulling the oil pump, do not plan to work ont he bottom end of the engine at all.

thanks dave
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Posts in this topic
dmenche914   removing oil pump   Feb 20 2004, 04:31 PM
ArtechnikA  
 

Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 

- Lo-Fi Version Time is now: 4th June 2024 - 08:52 AM
Invision Power Board v9.1.4 © 2024  IPS, Inc.
All rights reserved 914World.com © since 2002
914World.com is the fastest growing online 914 community!
We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ...