 Reverse Idler Gear, Tips for proper Clearance ? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| 2-OH! |
 Mar 1 2004, 02:34 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 552 Joined: 17-October 03 From: Santa Clarita, Kalifornication Member No.: 1,253  |
Hanyes manual says to set the clearance between the Reverse Idler and the sliding 1st shift gear to 1mm. The only problem is that the shaft for the Reverse Idler gear is roll pinned inside the rear cover so it's not possible to measure the distance, with the case on or without removing the pin...
Must be another way...Need some advice... 2-OH! |
   |
 
|
Posts in this topic
2-OH! Reverse Idler Gear Mar 1 2004, 02:34 PM
Bleyseng I used a deep dish socket that was the same diamet... Mar 1 2004, 08:05 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 15th July 2025 - 03:27 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.