 Acquired a 914-Need Your Help... She's Dead, Sitting for 20+years...Help me bring life with little $$ |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| tabs914 |
 Jul 29 2009, 08:44 AM
Post
#1
|
|
Advertise Your Drive...  Group: Members Posts: 105 Joined: 17-January 05 From: Gresham, Oregon Member No.: 3,456 Region Association: None  |
Update on 10/11/09: I ditched the old motor with a new one. So all the posts to page 4 I believe are for the old motor. I do have some issues that relate to the new motor on Page 5.... (IMG:style_emoticons/default/biggrin.gif) Thanks.
OK... first thing the fuel system and harness were removed because the previous owner wanted to convert it to a duel carb set-up. So I put the FI back in. I bought a fresh battery, oil, filters and replaced the all the fuel lines plus vacuum lines. Now I want to try to start the darn thing and all I get is a "click" noise from the starter... so i jack the left side leaving the right side on the ground and put it in 5th gear. I turn the tire front the back a few times in either direction. I try to start it agian... "click". So I do the opposite side, but this time on the right i can't move the tire at all... well it will move 2-3", but thats it. Brakes are free btw. I have seen on the www that "Miricle Oil" down the plug holes will free up the pistons if they are siezed. I just dont understand that I can rotate one side and not the other. Thanks for your help... (IMG:style_emoticons/default/rolleyes.gif) Update: Found Water in the Oil - Lots! (IMG:style_emoticons/default/confused24.gif) What to do? Rebuild? Lube the hell out of it? More Mystery oil? (IMG:style_emoticons/default/blink.gif) |
   |
 
|
Posts in this topic
tabs914 Acquired a 914-Need Your Help... She's Dead Jul 29 2009, 08:44 AM
mojorisen914 :ttiwwp: Jul 29 2009, 09:04 AM DonnyT if you can get a socket and breaker bar onto the f... Jul 29 2009, 09:08 AM tabs914 The car came with an extra starter... i replaced i... Jul 29 2009, 09:29 AM
Randal
The car came with an extra starter... i replaced ... Jul 29 2009, 09:34 AM jim_hoyland Rear wheel bearings may require replacement front ... Jul 29 2009, 09:36 AM tabs914 I can tell the resistance is internal not from the... Jul 29 2009, 09:49 AM ericread Check your grounds. The 914 is notorious for lett... Jul 29 2009, 09:51 AM Cupomeat Ok, on the subject of rotating the left side, but ... Jul 29 2009, 10:08 AM Heeltoe914 Your getting allot of great tips put your trucks o... Jul 29 2009, 10:17 AM carr914 It is not unusual for a new battery to not have a ... Jul 29 2009, 10:51 AM ConeDodger Grounds. Jul 29 2009, 11:09 AM Vacca Rabite Check grounds . Try a different (known good) batt... Jul 29 2009, 11:30 AM tabs914 Thank you all... I havent tried both wheels off th... Jul 29 2009, 12:48 PM Phoenix 914-6GT Don't miss the ground strap just above the tra... Jul 29 2009, 01:02 PM pktzygt I've got something that stumped me for a bit. ... Jul 29 2009, 01:30 PM tabs914
I've got something that stumped me for a bit.... Jul 29 2009, 02:14 PM Hammy Check and clean that tranny ground and also make s... Jul 29 2009, 02:01 PM Cupomeat Ok, good info, so that pretty much starts the prob... Jul 29 2009, 05:06 PM Kansas 914
OK... first thing the fuel system and harness wer... Jul 29 2009, 07:27 PM r_towle Pull the tranny out.
See if you can turn the motor... Jul 29 2009, 07:32 PM rick 918-S A couple good ideas here.
Mike is hinting at a li... Jul 29 2009, 07:40 PM tabs914 This is great... thank you all. OK so I get home w... Jul 30 2009, 08:42 AM RJMII did you pull the right rear wheel and check the co... Jul 30 2009, 02:15 PM tabs914
did you pull the right rear wheel and check the c... Jul 30 2009, 03:21 PM Cupomeat Ok, that sounds correct to me.
if the one wheel i... Jul 30 2009, 03:37 PM tabs914
Ok, that sounds correct to me.
if the one wheel ... Jul 30 2009, 04:17 PM type2man I'm thinking the clutch disc could be stuck on... Jul 30 2009, 04:06 PM tabs914
I'm thinking the clutch disc could be stuck o... Jul 30 2009, 04:15 PM DonnyT You should be able to turn the engine over by hand... Jul 30 2009, 06:48 PM DonnyT Had a problem once with a bad connection on the se... Jul 30 2009, 06:52 PM tabs914 Found evidence of water in the oil... I removed th... Jul 31 2009, 11:00 AM type47
Found evidence of water in the oil... I removed t... Jul 31 2009, 05:00 PM type47 Well, you say it's been sitting 20 years and f... Jul 31 2009, 04:56 PM r_towle water gets in for lots of reasons.
Is it alot of w... Jul 31 2009, 04:57 PM tabs914
water gets in for lots of reasons.
Is it alot of ... Jul 31 2009, 05:07 PM r_towle can you rotate the motor?
Here is my test.
If you... Jul 31 2009, 05:08 PM tabs914
can you rotate the motor?
Here is my test.
If yo... Jul 31 2009, 05:26 PM tabs914 Not by hand Jul 31 2009, 05:09 PM r_towle I added a bit more detail to what I mean "by ... Jul 31 2009, 05:13 PM tabs914 Hey Rich...thank you for your time. :D I can rot... Jul 31 2009, 05:17 PM tabs914 :Qarl: Engine finally broke loose today... now I c... Aug 4 2009, 06:59 PM tabs914 I got it crainking :Qarl: It was the grounds... ... Aug 7 2009, 12:53 AM McMark A little PB Blaster into the fuel pump can sometim... Aug 7 2009, 03:09 AM Vacca Rabite If the fuel pump was seized, would it be reliable ... Aug 7 2009, 08:57 AM kwales Sometimes it's varnish left over form dehydrat... Aug 7 2009, 09:17 AM tabs914 Thanks for the advice... I will try it. It can... Aug 7 2009, 10:04 AM tabs914 OK I got the pump working :Qarl: Now Im not gett... Aug 9 2009, 02:17 AM cwpeden go to this site for FI diagnosis tips, its helped ... Aug 9 2009, 04:07 AM tabs914
go to this site for FI diagnosis tips, its helped... Aug 11 2009, 06:25 PM McMark I don't understand what the newest problem is.... Aug 11 2009, 09:02 PM tabs914
I don't understand what the newest problem is... Aug 11 2009, 09:25 PM r_towle Post a close up pic of the coil wiring.
Rich Aug 11 2009, 09:26 PM tabs914
Post a close up pic of the coil wiring.
Rich
I... Aug 11 2009, 10:11 PM tabs914 Here are some pics of the car... :D Aug 11 2009, 09:38 PM tabs914 some more... Aug 11 2009, 10:06 PM McMark Tracing backwards from the coil, with the key on:
... Aug 12 2009, 12:01 AM tabs914
Tracing backwards from the coil, with the key on:... Aug 15 2009, 11:15 AM tabs914 well it appears I don't have pin 8 or 9 on the... Aug 12 2009, 09:21 PM tabs914 Here are the volt readings with the ignition on. B... Aug 15 2009, 10:25 AM Dr Evil Was your plug messed with?
Your coil is correctly ... Aug 15 2009, 11:33 AM tabs914 So the green heater wire shouldn't be plugged ... Aug 15 2009, 11:42 AM Dr Evil Ya, that would explain the power on the pin. That ... Aug 15 2009, 12:00 PM tabs914
Ya, that would explain the power on the pin. That... Aug 15 2009, 12:05 PM Dr Evil :thumbsup: Aug 15 2009, 12:07 PM tabs914 OK... I put a new condenser on and it seems to be ... Aug 15 2009, 03:51 PM Dr Evil What do you mean it wont distribute? How do you kn... Aug 15 2009, 05:13 PM tabs914 the plug wire off the coil is creating a spark, bu... Aug 15 2009, 05:38 PM Dr Evil Ah, is the rotor installed? There is no reason oth... Aug 15 2009, 05:46 PM tabs914 ok I think im good...I put the tester on it and it... Aug 15 2009, 05:54 PM McMark
Mike, this'll have power if the points are cl... Aug 15 2009, 07:34 PM Dr Evil Mark, ya, but he said the power for the blower was... Aug 15 2009, 08:30 PM tabs914
Mark, ya, but he said the power for the blower wa... Aug 17 2009, 09:30 PM tabs914 :bump: Aug 18 2009, 08:36 PM tabs914 Update: I have her starting up but zero idle. What... Aug 22 2009, 08:45 PM tabs914 OK... have a vid, the sound is terrible., but here... Aug 25 2009, 09:56 PM McMark I'd check fuel pressure and timing first. Aug 25 2009, 11:27 PM tabs914 ***Update*** Ditched the old motor. Oil leaks, rus... Sep 28 2009, 12:57 PM tabs914 New Motor Pic Sep 28 2009, 01:00 PM Cupomeat It is hard to tell, but the small threaded holes, ... Sep 28 2009, 01:28 PM tabs914 It's off a BMW I don't have the cone on th... Sep 28 2009, 01:36 PM Cupomeat Ah, this makes sense now.
These are the Air Injec... Sep 28 2009, 01:56 PM tabs914
Ah, this makes sense now.
These are the Air Inje... Sep 28 2009, 01:59 PM SLITS Whatever engine you have is a '75-'76.
I ... Sep 28 2009, 02:04 PM tabs914 Hey if some one knows the length thread and diamet... Sep 28 2009, 02:10 PM SLITS I'll check in in a bit if I can and measure th... Sep 28 2009, 02:17 PM SLITS While possibly not the correct thread,
M10 X 1.25... Sep 28 2009, 02:56 PM Thomas J Bliznik
While possibly not the correct thread,
M10 X 1.2... Oct 11 2009, 03:59 PM tabs914 I have been working on the brakes for the last cou... Oct 11 2009, 10:35 AM tabs914 I will elaborate what I have done so far...
1. Ch... Oct 11 2009, 11:34 AM tabs914 :bump: Oct 11 2009, 03:03 PM tod914 Did you reinspect your points to see if they are f... Oct 11 2009, 03:33 PM tabs914 Points look good...I am getting spark. I checked p... Oct 11 2009, 06:13 PM tabs914 :bump: Bump Oct 12 2009, 02:20 PM Gint Update on 10/11/09: I ditched the old motor with a... Oct 12 2009, 02:28 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 3rd June 2024 - 05:21 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.