 Upgraded my welder to MIG, CO2/ Argon mix. PSI recommendations |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
  |
| Gint |
 Dec 19 2009, 01:19 PM
Post
#21
|
|
Mike Ginter  Group: Admin Posts: 16,098 Joined: 26-December 02 From: Denver CO. Member No.: 20 Region Association: Rocky Mountains   |
I'd have to go out and look, but I think the last time I set mine, 15 psi wasn't quite enough for given situation and I bumped it up to 20. I'm always welding in the garage and the door is usually open. Perhaps that's why. But I haven't touched it since then as it gets the job done and I'm not screwin with it constantly.
|
   |
 
|
| al weidman |
Dec 21 2009, 10:36 PM
Post
#22
|
|
Al Weidman Group: Members Posts: 156 Joined: 22-February 08 From: Oroville, Ca. Member No.: 8,736 Region Association: Northern California |
|
|
|
|
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 31st July 2025 - 07:32 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.