 Making more progress. |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
  |
| KaptKaos |
 Apr 25 2010, 12:03 PM
Post
#1
|
|
Family  Group: Members Posts: 4,009 Joined: 23-April 03 From: Near Wausau Member No.: 607 Region Association: Upper MidWest  |
Since I have to go to a birthday party in an hour, I missed the G&R again. However, I did get a few minutes this morning to myself and was able to install the new rings on my pistons.
I plan to put the barrels on tonight and maybe even the heads... woo hoo!! The question of the day is: The guy that built the motor that I am redoing the top end on, used blue RTV at the base of the cylinders where they meet the case. Should I do the same? There are a lot of pros and cons, so I am looking for input. There is a shim on each cylinder Oh - what's the torque spec on the head nuts? Is there a good pattern to follow when tightening? TIA. |
   |
 
|
| KaptKaos |
Apr 26 2010, 03:23 PM
Post
#2
|
|
Family Group: Members Posts: 4,009 Joined: 23-April 03 From: Near Wausau Member No.: 607 Region Association: Upper MidWest |
|
|
|
|
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 15th May 2024 - 04:43 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.