 how do you remove the dizzy drive |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
  |
| ruddyboys |
 Apr 4 2004, 12:08 PM
Post
#1
|
|
Hummel eigentümer  Group: Members Posts: 594 Joined: 3-March 04 From: Monroe, NY Member No.: 1,749 Region Association: North East States  |
Never could get the dizzy to line up like I see pics of. Pulled the dizzy (its a sh@ty 009 from PO) and get the motor to TDC. The blower notch lines up and the notch on ther tranny lines up. I look down were the dizzy was and instead of the slot being 12 degrees of center it is was way off. How do you pull the gear to get it to align the right way.
|
   |
 
|
| McMark |
Apr 4 2004, 01:22 PM
Post
#2
|
|
914 Freak! Group: Retired Admin Posts: 20,179 Joined: 13-March 03 From: Grand Rapids, MI Member No.: 419 Region Association: None |
There is a thread about this (written by yours truly) in the classic threads forum.
Dizzy Drive Thread |
|
|
|
| ChrisFoley |
Apr 4 2004, 02:14 PM
Post
#3
|
|
I am Tangerine Racing Group: Members Posts: 7,920 Joined: 29-January 03 From: Bolton, CT Member No.: 209 Region Association: None 
|
I use a flat wooden stick that is just thick enough with a bit of tape to fit snugly in the groove. Piece of cake.
|
|
|
|
| 415PB |
Apr 4 2004, 03:57 PM
Post
#4
|
|
Member Group: Benefactors Posts: 498 Joined: 7-August 03 From: So Cal Member No.: 996  |
I use snap ring pliers and it works pretty good. Had to fish for the washer though.
|
|
|
|
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 3rd May 2024 - 05:02 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.