Test fitting doors, gap is off, FML |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Test fitting doors, gap is off, FML |
Gearhead1432 |
Aug 29 2010, 01:50 PM
Post
#1
|
Member Group: Members Posts: 129 Joined: 21-December 05 From: Altus, OK Member No.: 5,304 Region Association: None |
I have the right side inner rocker all welded up as well as the hell hole and jack post. Is now is the time to test fit the doors before I weld in the door sill and quarter pannel? I think it should be fine. I'm concerned the chassis may have warped and I'd like to be sure before I finish the rest of the welding.
Thanks, Rob |
cary |
Sep 3 2017, 09:47 AM
Post
#2
|
Advanced Member Group: Members Posts: 3,900 Joined: 26-January 04 From: Sherwood Oregon Member No.: 1,608 Region Association: Pacific Northwest |
I picked the car last Sunday afternoon. Gearhead1432 is being re-stationed in Oklahoma for the next 4 years so he asked if could get his project restarted. Primary scope of work asked for, R & R rusted areas. But first thing will be to take chassis measurements and see where's he's at. At first glance his re-cut and weld on the long looks good. His hell hole repair looks tidy.
We probably won't touch it till around Christmas. It will give him time to decide whether to strip it down and epoxy primer the tub. Not my call, I'm just the hired gun. But that is my preferred method. So we start with a clean slate. Outsourced : Est. $3k. Attached image(s) |
Lo-Fi Version | Time is now: 24th May 2024 - 05:08 AM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |