 Jack Tube Depth in Long |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| TargaToy |
 Sep 4 2010, 08:55 AM
Post
#1
|
|
-NONSOLIS RADIOS SEDIOUIS FULMINA MITTO-  Group: Members Posts: 692 Joined: 26-March 10 From: DelMarVa Peninsula Member No.: 11,509 Region Association: MidAtlantic Region 
 |
Once upon a time, I saw here a CAD diagram someone made which showed how deep into the long the "backing plate" of the jack tube went. Since both of mine were gone, I don't have any points of reference and I'm getting ready to fabricate the inner plate and install the new pyramid and tube.
I know I can always grind the tube on the outer end so that it's flush with the rocker panel later if I install it too "proud", but I'd like to have as much tube as possible in the car for the jack to engage in. Make sense? Does anybody remember seeing that diagram? I wasn't able to turn it up with a search. Thanks! |
   |
 
|
Posts in this topic
TargaToy Jack Tube Depth in Long Sep 4 2010, 08:55 AM
charliew On my 75 the jack tubes are 2.5 inches deep. They ... Sep 4 2010, 09:02 AM Richard Casto This is my research into the same issue. Not sure... Sep 4 2010, 03:13 PM TargaToy Richard, you rock!
That was exactly the diagr... Sep 6 2010, 08:01 AM
charliew Now I am concerned that the earlier repair on my 7... Sep 6 2010, 02:36 PM Richard Casto
Richard, you rock!
That was exactly the diag... Sep 7 2010, 08:51 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 18th May 2024 - 03:37 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.