 jackpoint care, cleaned out the dirt.. now what? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| dem |
 Oct 2 2010, 08:36 PM
Post
#1
|
|
Rusty Member  Group: Members Posts: 147 Joined: 7-February 10 From: Cupertino, CA Member No.: 11,334 Region Association: Northern California  |
Well, I was rebuilding my doors (stays, lube, door handle gasket, etc.) and found out my driver's side interior door handle is half broken (see my WTB in classifieds if you have one handy!)
So, since I am waiting to get a handle, I decided to pull my rocker and clean out the dirt. Not so bad compared to many - maybe a half a cup of dirt. Some of it obviously painted over in 1997 - nice. Anyways, after cleaning it up.. it doesn't seem to be in cut-off-and-replace state.. but what should I do to it before buttoning it back up? Wire wheel and some rattlecan? I'm telling myself if I have the car in 10 years, I'll spring for a full strip & repaint, but until then, it's "maintenance mode."  |
   |
 
|
Posts in this topic
dem jackpoint care Oct 2 2010, 08:36 PM
TargaToy A couple of those spots AROUND the jackpost look s... Oct 2 2010, 08:52 PM
RickS I just went through this a week ago except about 2... Oct 2 2010, 11:04 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 17th May 2024 - 04:36 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.