 d-jet a.a.r. question, 8/18/ AAR open vs closed - effect on setting timing-advance |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| DRPHIL914 |
 Aug 10 2011, 08:50 PM
Post
#1
|
|
Dr. Phil  Group: Members Posts: 5,767 Joined: 9-December 09 From: Bluffton, SC Member No.: 11,106 Region Association: South East States 
 |
I e tested 4 now and after 10 min none of them close completely or at all. Either way could it be because of a bad connection? Not hot enough? I know atleast one, the newest one was tested as good and is very clean. I know they can go bad inside but I do not think they all are.
But after 10 min of car at idle its still pulling air thru, suggestions please. Phil |
   |
 
|
Posts in this topic
Philip W. d-jet a.a.r. question Aug 10 2011, 08:50 PM
ConeDodger Yes, heat. I assume from the 12 volt source coming... Aug 10 2011, 08:55 PM Valy is that the l-jet or the d-jet aar?
I know the l-j... Aug 10 2011, 09:07 PM ConeDodger Here is a link to Brad Anders DJet site. It outlin... Aug 10 2011, 09:09 PM Tom The AAR for D-jet needs two things to work on the ... Aug 10 2011, 09:39 PM McMark The AAR uses a bimetallic strip to rotate a step-c... Aug 10 2011, 10:45 PM cary As long as we're on the subject. I've had ... Aug 11 2011, 07:39 AM r_towle They get pretty warm, and the heat from the case a... Aug 11 2011, 07:42 AM
Philip W.
They get pretty warm, and the heat from the case ... Aug 11 2011, 08:21 AM Tom The AAR typically draws about 1 to 1.5 amps. They... Aug 11 2011, 08:33 AM underthetire
The AAR typically draws about 1 to 1.5 amps. The... Aug 11 2011, 09:08 AM euro911 I just refurbished a couple of them recently. They... Aug 11 2011, 08:35 PM Philip W.
I just refurbished a couple of them recently. The... Aug 13 2011, 03:05 PM swl The AAR is on the small FI harness - connected to ... Aug 13 2011, 04:20 PM Philip W.
The AAR is on the small FI harness - connected to... Aug 13 2011, 05:35 PM Tom Voltage is only at the AAR when the fuel pump is r... Aug 13 2011, 06:17 PM swl You can check it with an ohm meter with power off.... Aug 13 2011, 07:33 PM euro911 I tested the electrical function using a VOM to de... Aug 14 2011, 12:00 PM Philip W. OK. so ran the car for 10 minutes- yes we are on t... Aug 17 2011, 10:59 AM ConeDodger
OK. so ran the car for 10 minutes- yes we are on ... Aug 17 2011, 11:18 AM Tom Take the AAR hose that goes to the air cleaner off... Aug 17 2011, 11:36 AM scott_in_nh
Take the AAR hose that goes to the air cleaner of... Aug 17 2011, 11:43 AM Philip W.
Take the AAR hose that goes to the air cleaner o... Aug 17 2011, 02:12 PM scott_in_nh
good question- i got the current MPS in a parts b... Aug 17 2011, 02:23 PM Philip W.
good question- i got the current MPS in a parts ... Aug 17 2011, 07:43 PM Philip W. I had a thought on this, wondering if this makes s... Aug 18 2011, 06:13 AM scott_in_nh
I had a thought on this, wondering if this makes ... Aug 18 2011, 06:24 AM Philip W.
I had a thought on this, wondering if this makes... Aug 18 2011, 07:08 AM scott_in_nh
Scott, i was playing around with that last night... Aug 18 2011, 08:34 AM Philip W.
Scott, i was playing around with that last nigh... Aug 20 2011, 03:08 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 27th May 2024 - 12:00 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.