 How to remove jugs from heads? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| tornik550 |
 Sep 24 2011, 09:12 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,248 Joined: 29-January 07 From: Ohio Member No.: 7,486 Region Association: None  |
I have never had this issue before. I have new AMC heads and new EMW 96mm clyinders. I assembled the longblock to check valve train geometry. I need to send my heads off to get the valve guide bosses cut however I cannot remove the jugs from the heads. I do not want to break any fins so I haven't tried much other than muscle.
Any ideas? Attached image(s) 
|
   |
 
|
Posts in this topic
tornik550 How to remove jugs from heads? Sep 24 2011, 09:12 AM
Dr Evil Heat. Torch the interface where the heads meet the... Sep 24 2011, 09:24 AM vsg914 Uh, something is seriously wrong. I think amc head... Sep 24 2011, 09:26 AM
tornik550
Uh, something is seriously wrong. I think amc hea... Sep 24 2011, 09:45 AM Dr Evil
Uh, something is seriously wrong. I think amc he... Sep 24 2011, 10:17 AM tornik550
[quote name='tornik550' post='1543697' date='Sep ... Sep 24 2011, 04:45 PM Dr Evil Air pressure against what? There is nothing but op... Sep 24 2011, 09:27 AM vsg914 Ha ha. You are absolutely right. Duh! Need cof... Sep 24 2011, 09:33 AM r_towle rubber mallet and some well placed taps (dont be s... Sep 24 2011, 09:58 AM Jake Raby This is not an interference fit. You hace an issue... Sep 24 2011, 12:53 PM tornik550
This is not an interference fit. You hace an issu... Sep 24 2011, 02:20 PM ripper911 Using a scalpel with a #22 blade, make an incision... Sep 24 2011, 01:02 PM poorsche914
Using a scalpel with a #22 blade, make an incisio... Sep 24 2011, 02:10 PM tornik550
Using a scalpel with a #22 blade, make an incisio... Sep 24 2011, 02:17 PM HAM Inc This could be traced to sagging case spigots. The ... Sep 25 2011, 07:54 AM tornik550
This could be traced to sagging case spigots. The... Sep 25 2011, 08:13 AM HAM Inc You need to also make sure that the head registers... Sep 25 2011, 08:54 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 25th May 2024 - 07:13 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.