 no-start update |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| MarkG |
 Aug 2 2004, 08:43 PM
Post
#1
|
|
Member  Group: Members Posts: 314 Joined: 24-May 04 From: Colorado Springs Member No.: 2,102  |
Well my 'new' '76 still doesn't run, but didn't really expect it to with what I've done so far (remember it had wondering idle so I removed the TB cleaned it etc and it never ran for more than a minute since....)
I pulled the dizzy and replaced FI points, breaker plate, condenser, rotor, cap, NGK BP6Es plugs, wires and coil (Jacobs on the last 2). Adjusted TPS. CHT seems to perhaps has a poor connection (wires cut/spliced by PO). Tested MPS and it failed vacuume hold test. Rebuilt one on order, new TPS on order, new CHT here, as are all vacuume lines and manifold boots. Sending TB and injectors to EBS for rebuild and calibration (TB shaft has play and base is warped). I will pull the manifolds etc this week and verify no issues there or with plenum, then re-hose and re-boot everything. PCV...don't see one....have a male connection comming off of oil fill cap plate with hose to air filter, but no PCV that I can see.....any ideas? Thanks guys!! Mark |
   |
 
|
Posts in this topic
MarkG no-start update Aug 2 2004, 08:43 PM
Brad Roberts 76 didnt use a PCV on the oil filler. You *probabl... Aug 2 2004, 09:53 PM MarkG New manifold gaskets and injector seals here alrea... Aug 3 2004, 08:54 AM
Dave_Darling The plenum has three legs that go down to the case... Aug 3 2004, 12:10 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 17th May 2024 - 10:08 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.