 Is this piece structurally important?, Question for the pros |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Matt914MI |
 Apr 26 2003, 10:34 PM
Post
#1
|
|
Newbie  Group: Members Posts: 37 Joined: 6-February 03 From: Zeeland, MI Member No.: 260 Region Association: None  |
Alright guys, I'm finally getting more of the rusted through floorpan cut out, but I need to know it this piece is structurally significant.
(IMG:http://mcchicken.homeip.net:2080/pics/2003-04-26/CNXT0009.JPG) It's almost rusted through, and I'd like to cut it out, but I don't know. If it is important, can I weld in some tubing a little in front of it and cut out what's there? All I know is that this is a huge project, and I'm really sick of scraping out all that tar shit. |
   |
 
|
  |
Replies
| Gint |
Apr 26 2003, 11:31 PM
Post
#2
|
|
Mike Ginter Group: Admin Posts: 16,071 Joined: 26-December 02 From: Denver CO. Member No.: 20 Region Association: Rocky Mountains  |
I don't think that cross piece has any structural significance to the chassis itself. I wouldn't remove it though for the same reasons that have already been mentioned.
BTW - I removed half of the tar from my floor pans today. Get a heat gun. Heat that stuff up a little bit, and it comes right up fairly easily. I'll have the rest done and the pan clean with about 3 more hours work tomorrow |
|
|
|
Posts in this topic
Matt914MI Is this piece structurally important? Apr 26 2003, 10:34 PM
Zeke As you already can see, it holds the seat adjustme... Apr 26 2003, 10:47 PM rick 918-S I would think without the cross member the floor p... Apr 26 2003, 10:54 PM SirAndy nope, we take them out on all the race cars to mou... Apr 27 2003, 12:42 AM Brad Roberts The piece is more for side impact protection than ... Apr 27 2003, 01:01 AM Matt914MI Thanks guys. I figured it wasn't too importan... Apr 27 2003, 10:49 AM Curvie Roadlover MAtt,
Where in MI are you located? Apr 27 2003, 11:25 AM Lawrence914-6 If you're going to cut it out, make sure you m... Apr 27 2003, 11:28 AM brant Brad,
I had this piece cut out on my club racer ... Apr 27 2003, 12:39 PM
Matt914MI Well, it's cut out now, along with most of the... Apr 27 2003, 06:19 PM |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 16th May 2024 - 05:20 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.