 what did you do to your 914 today |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| mrbubblehead |
 Dec 17 2011, 08:07 PM
Post
#1
|
|
Twodollardoug  Group: Members Posts: 1,155 Joined: 17-December 10 From: calimesa ca. Member No.: 12,492 Region Association: Southern California  |
i just wanted to start a thread to see what you guys do day to day on your cars.
i'll start, about a month ago, i pulled my engine and trans to put in a new clutch. had the flywheel lightened and resurfaced. but what i didnt know is that i had to shim the little ball that the clutch arm rides on, after a resurfacing. so guess what i did today? yup, pulled the trans and put an extra washer under the ball. you have to goop up both washers to get it to seal because the threaded hole goes all the way thru to the inside of the trans. i also replaced the plastic cup that the ball rides in. the throwout bearing and its little plastic blocks were fine so i buttoned every thing back up. 5 hours total. i think this has been the cheapest repair yet on my car. $2.75 for the little plastic cup. what did you do to your 914 today? |
   |
 
|
Posts in this topic
mrbubblehead what did you do to your 914 today Dec 17 2011, 08:07 PM
ndfrigi Received my Jwest item too few months ago and plan... Apr 7 2016, 09:45 AM kkid Went to Finish master to get some paint to redo my... Apr 7 2016, 10:41 AM
poorsche914 Went to Finish master to get some paint to redo my... Apr 7 2016, 08:30 PM ClayPerrine
Went to Finish master to get some paint to redo m... Apr 8 2016, 11:33 AM raw1298 Started glass work on rear bumper shaping it to fi... Apr 7 2016, 08:10 PM jim_hoyland After doing a radio delete I set up my iPod. Insta... Apr 8 2016, 05:59 PM 914dave Front trunk, cowl, windshield frame and front pane... Apr 8 2016, 06:00 PM wndsnd In with a shoe horn and much help from a fellow Te... Apr 8 2016, 07:27 PM Madswede I straightened out the poorly-installed (by me) Eu... Apr 8 2016, 11:20 PM abes914
I straightened out the poorly-installed (by me) E... Apr 9 2016, 12:53 AM mgp4591 I love the rear light panel treatment! I'v... Apr 9 2016, 01:08 AM Madswede
I love the rear light panel treatment! I... Apr 9 2016, 08:06 AM Cairo94507 Beautiful car. :trophy: Apr 9 2016, 06:22 AM RickS Are the rockers custom or off the shelf and if so ... Apr 9 2016, 08:37 AM Madswede
Are the rockers custom or off the shelf and if so... Apr 9 2016, 09:52 AM RickS Oh and before I was distracted, installed a new fu... Apr 9 2016, 08:40 AM Larmo63 I installed a Momo wheel/hub that I bought here. I... Apr 9 2016, 02:54 PM Larmo63 I also installed some much better and brighter vin... Apr 9 2016, 02:57 PM Larmo63 RE: what did you do to your 914 today Apr 9 2016, 02:58 PM carr914 Installed 5 Lug Kit, rear Coilovers, Monoballs, 91... Apr 9 2016, 05:15 PM euro911 Cleaned up the mess of stuff in my front driveway ... Apr 9 2016, 06:44 PM SKL1 Took my '71 out for its first drive of the yea... Apr 9 2016, 07:35 PM euro911 Might be a grounding issue :confused:
I had a s... Apr 9 2016, 11:49 PM jfort Got it ready for Hershey Apr 10 2016, 06:28 AM Cairo94507 :trophy: :trophy: Absolutely stunning. Apr 10 2016, 06:42 AM Alphaogre Finally got the rear fiberglass bumper mounted wit... Apr 10 2016, 04:19 PM jim_hoyland
Finally got the rear fiberglass bumper mounted wi... Apr 10 2016, 05:52 PM Alphaogre
Finally got the rear fiberglass bumper mounted w... Apr 10 2016, 07:13 PM jim_hoyland
[quote name='jim_hoyland' post='2328758' date='Ap... Apr 10 2016, 07:30 PM Alphaogre
[quote name='Alphaogre' post='2328809' date='Apr ... Apr 11 2016, 12:28 AM whitetwinturbo Looking for Brake Master Cyc information!
I... Apr 10 2016, 05:16 PM MJHanna
Looking for Brake Master Cyc information!
... Apr 10 2016, 05:34 PM euro911 They never used a 14mm bore to my knowledge. 914s ... Apr 10 2016, 05:34 PM whitetwinturbo So do I have a "19" ??? Apr 10 2016, 05:37 PM MJHanna
So do I have a "19" ???
Yes you bought... Apr 10 2016, 05:54 PM whitetwinturbo
So do I have a "19" ???
Yes you bough... Apr 11 2016, 04:07 PM type2man Dismantled my widebody 914-6 (fake) in order to us... Apr 10 2016, 06:17 PM saigon71 Finally addressed one of those annoying little pro... Apr 10 2016, 06:25 PM 6freak PUT SOME FRESH GAS IN IT AND DROVE IT FOR 20 MILES... Apr 11 2016, 03:24 PM Coondog
PUT SOME FRESH GAS IN IT AND DROVE IT FOR 20 MILE... Apr 11 2016, 04:16 PM SKL1
Going to bleed brakes again... can't seem ... Apr 12 2016, 10:06 PM SA-914 I sure wish my wife let me work on cars in a bedro... Apr 13 2016, 09:42 AM Alphaogre
Going to bleed brakes again... can't seem... Apr 13 2016, 10:17 PM Cairo94507 SKL1 - :trophy: :trophy: That is one fine lookin... Apr 13 2016, 06:58 AM 1stworks Impromptu track day in 914 V8.
Short course.
sW_3... Apr 15 2016, 08:01 AM timothy_nd28 Putting that batwing oil pan to full use :D Apr 15 2016, 08:06 AM 1stworks
Putting that batwing oil pan to full use :D
... Apr 15 2016, 08:21 AM Shadowfax Installed a working Kienzle clock in my center con... Apr 15 2016, 08:42 AM JFG Today i started stripping the front end ready for ... Apr 15 2016, 12:32 PM maddin Engine out again..getting new head studs and a clo... Apr 17 2016, 05:18 AM napasteve Went for a quick drive after my SS fuel lines/new ... Apr 19 2016, 09:49 AM Dion Built some ramps and put the U-boat on the new to ... Apr 19 2016, 07:11 PM BeatNavy
Built some ramps and put the U-boat on the new to... Apr 20 2016, 03:48 AM cary After slaving under hot 914's all day. I washe... Apr 19 2016, 10:43 PM Dion That was me Rob, thanks for the compliment. I was... Apr 20 2016, 05:24 AM Rav914 I drove my car last in Aug '15 right before my... Apr 20 2016, 02:28 PM nein14 Got the doors and the fiberglass lid back from the... Apr 20 2016, 03:01 PM OU812
I took the rockers off to get a look at the outsi... Apr 20 2016, 06:26 PM Philip W. what I did YESTERDAY was decide to chase the cutti... Apr 21 2016, 07:39 AM Coondog Wash and waxed for Arz run........
Apr 21 2016, 07:43 PM Larmo63 Getting ready to drop the 4 cylinder engine and th... Apr 21 2016, 07:59 PM Hans Jan Last Friday my (new for me) 914 caught fire in the... Apr 21 2016, 08:27 PM ClayPerrine
Last Friday my (new for me) 914 caught fire in th... Apr 21 2016, 08:42 PM Hans Jan
Last Friday my (new for me) 914 caught fire in t... Apr 21 2016, 09:31 PM ClayPerrine
[quote name='ClayPerrine' post='2334197' date='Ap... Apr 22 2016, 11:24 AM mepstein
[quote name='ClayPerrine' post='2334197' date='Ap... Apr 22 2016, 02:35 PM michael7810 Side shift and yes you need a protective booth Apr 21 2016, 08:44 PM raw1298 Getting ready for next project. Apr 21 2016, 09:54 PM 914_teener
Getting ready for next project.
I just finishe... Apr 22 2016, 03:25 PM Alphaogre Productive day yesterday. Installed the "Tuna... Apr 22 2016, 02:17 PM Puebloswatcop
Productive day yesterday. Installed the "Tun... Apr 22 2016, 07:49 PM Puebloswatcop Started cutting up my '73 Donor Car :sawzall: Apr 22 2016, 07:46 PM OU812 Picking up my Fourth car today......So Not necessa... Apr 23 2016, 06:04 AM 396 New five arm Baum. Quality stuff vs the other... Apr 23 2016, 09:37 AM ndfrigi Breakfast meet this morning with Jacquot, Bob, Abe... Apr 23 2016, 03:32 PM dangrouche I did a tabletop conversion ! Apr 23 2016, 04:53 PM Menmojo Installed a new flex dam spoiler.
Thanks to 914rub... Apr 23 2016, 05:12 PM Coondog Top 3 Fav 914 color.......Beautiful Apr 23 2016, 05:16 PM michael7810 Replaced the frunk (got the new one that sits lowe... Apr 23 2016, 05:29 PM cary I'm finally in a position where I could take a... Apr 23 2016, 09:35 PM cary
At the end of the day I covered 354 miles in my ... Apr 24 2016, 04:32 PM Larmo63 I dropped the 2.0 /4 motor yesterday afternoon, I ... Apr 23 2016, 11:22 PM porschetub
I dropped the 2.0 /4 motor yesterday afternoon, I... Apr 23 2016, 11:32 PM Larmo63
I dropped the 2.0 /4 motor yesterday afternoon, ... Apr 24 2016, 05:04 PM Chris914n6 Adventures in 4teenering
http://www.914world.com/... Apr 24 2016, 05:34 PM db9146 I added the 3 meter version of BlazeCut for an add... Apr 24 2016, 07:36 PM lonewolfe
I added the 3 meter version of BlazeCut for an ad... Apr 24 2016, 09:05 PM Mike Bellis I drove it... :driving:
Then I hooked up my flat... Apr 24 2016, 07:46 PM ThinAir Engine and transmission got reinstalled in the car... Apr 24 2016, 08:33 PM OU812 Continued disassembling the first of four cars. Cl... Apr 24 2016, 09:04 PM 76-914 Cleaned and polished my Fuch's. :FERG: Apr 25 2016, 09:44 AM JFG continued the strip down today. Just about ready ... Apr 25 2016, 12:58 PM ndfrigi cleaned used euro tail lights for my 75 1.8 FI.
Apr 27 2016, 10:04 AM Philip W. replaced an injector after isolating an intermitte... Apr 27 2016, 11:03 AM SirAndy :pat: Apr 27 2016, 11:17 AM Kansas 914 I just finished detailing the '75 just to driv... Apr 27 2016, 03:28 PM Larmo63 :WTF:
Is that car pink? Apr 27 2016, 04:01 PM SirAndy :WTF:
Is that car pink?
That's "Raspber... Apr 27 2016, 04:44 PM snakemain I investigated the reason why I seem to only be ru... Apr 29 2016, 09:35 PM  |
58 User(s) are reading this topic (57 Guests and 0 Anonymous Users)
1 Members: KSCarrera
|
Lo-Fi Version | Time is now: 7th March 2026 - 03:35 AM |
Invision Power Board
v9.1.4 © 2026 IPS, Inc.