 what did you do to your 914 today |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| mrbubblehead |
 Dec 17 2011, 08:07 PM
Post
#1
|
|
Twodollardoug  Group: Members Posts: 1,155 Joined: 17-December 10 From: calimesa ca. Member No.: 12,492 Region Association: Southern California  |
i just wanted to start a thread to see what you guys do day to day on your cars.
i'll start, about a month ago, i pulled my engine and trans to put in a new clutch. had the flywheel lightened and resurfaced. but what i didnt know is that i had to shim the little ball that the clutch arm rides on, after a resurfacing. so guess what i did today? yup, pulled the trans and put an extra washer under the ball. you have to goop up both washers to get it to seal because the threaded hole goes all the way thru to the inside of the trans. i also replaced the plastic cup that the ball rides in. the throwout bearing and its little plastic blocks were fine so i buttoned every thing back up. 5 hours total. i think this has been the cheapest repair yet on my car. $2.75 for the little plastic cup. what did you do to your 914 today? |
   |
 
|
Posts in this topic
mrbubblehead what did you do to your 914 today Dec 17 2011, 08:07 PM
13b914 I finished my 350Z grille finally!
Mar 30 2012, 05:05 PM 2xs performance I removed the rear window , and some more trim tod... Mar 30 2012, 05:28 PM Cevan I finally got around to replacing the bushing in m... Mar 31 2012, 06:02 AM bulitt Cut out Rust... :sawzall: :rotfl: Mar 31 2012, 06:20 AM
poorsche914 Replaced my door panels with speaker cutouts...
... Mar 31 2012, 01:22 PM Nozzle Replaced my dead Bosch reman starter with a new mi... Mar 31 2012, 02:58 PM kconway FINALLY, installed my 2.4 in my car today! Co... Mar 31 2012, 04:14 PM euro911 FINALLY, installed my 2.4 in my car today! Co... Mar 31 2012, 07:33 PM kconway
FINALLY, installed my 2.4 in my car today! C... Mar 31 2012, 09:40 PM FL 000 Finished bleeding my brakes with nice and firm ped... Mar 31 2012, 04:35 PM matthepcat Painted my side skirts.
Fixed a coolant & exh... Mar 31 2012, 06:48 PM mojorisen914 Replaced the ignition switch after 6 months of no ... Mar 31 2012, 07:23 PM mikelsr Looked at it. Mar 31 2012, 07:42 PM '73-914kid Retired it as a daily driver.... :( Mar 31 2012, 07:43 PM Lennies914 Primed and prepped the deck lids and doors for pai... Mar 31 2012, 07:55 PM Garold Shaffer With my project car I finished removing the front ... Mar 31 2012, 08:01 PM pnewman
With my project car I finished removing the front... Mar 31 2012, 11:00 PM 914.SBC Today I said goodbye to my friend. My V8 conversio... Mar 31 2012, 08:28 PM ppetion I installed the door panels wih some nice speakers... Mar 31 2012, 10:56 PM rick 918-S RE: what did you do to your 914 today Mar 31 2012, 11:18 PM Travis Neff Your in high gear now!!!
Mar 31 2012, 11:56 PM KaptKaos Changed the oil and adjusted the valves.
Tomorr... Mar 31 2012, 11:39 PM mrbubblehead hey kapt, did you get my notes?
Changed the oil an... Apr 1 2012, 12:13 AM euro911 Did a little pre-spring cleaning at the shop today... Apr 1 2012, 12:17 AM Harpo
I trailered my car down to 914LTD so Brad can re... Apr 1 2012, 05:54 AM 2xs performance Changed out my fuel pump. While I was at it I relo... Apr 1 2012, 12:27 PM 2xs performance Might have a problem................ :huh:
The ... Apr 1 2012, 01:41 PM euro911 I'd move it up front, out of the engine bay, b... Apr 1 2012, 02:00 PM 2xs performance
I'd move it up front, out of the engine bay, ... Apr 1 2012, 02:15 PM Jeffs9146 Finishing the paint on Lennies914's car! Apr 1 2012, 04:53 PM JRust I drove mine into town to Redbox for some movies. ... Apr 1 2012, 05:05 PM bulitt Hit the longs with a hammer and watched the rust f... Apr 1 2012, 05:06 PM DNHunt New fuel lines, fuel level sender gasket, filler n... Apr 1 2012, 05:15 PM dlee6204
Hit the longs with a hammer and watched the rust ... Apr 1 2012, 05:42 PM pnewman Blasted and sprayed my window regulators with cold... Apr 1 2012, 09:16 PM Rand Removed the PO's Porsche reflector between the... Apr 1 2012, 09:40 PM Rockaria Froze it then drank it ...
Apr 1 2012, 09:44 PM euro911 Froze it then drank it ...
[color=#3333FF]COOL
P... Apr 1 2012, 11:15 PM sixnotfour
Froze it then drank it ...
[b][color=#3333FF]COO... Apr 2 2012, 12:07 AM Rockaria There is a person on Ebay selling silicone molds o... Apr 2 2012, 08:18 AM 914itis
Installed new carpet and seats, i am almost re... Apr 1 2012, 09:54 PM bulitt Installed Rear Bilstein Coilovers.
Rebuilt a Rear ... Apr 2 2012, 04:30 AM stuttgart46 Removed the rear decklid and started prepping the ... Apr 2 2012, 06:29 AM RobW Took off the front FG bumper and FG valence. Clean... Apr 2 2012, 06:56 AM PThompson509 Replaced all the connectors on the motor controlle... Apr 2 2012, 11:12 AM Aaron Cox pulled the scheel seats out,
pulled out old carpet... Apr 2 2012, 11:34 AM nickp997 Changed TPS board. What a difference and many than... Apr 2 2012, 11:37 AM poorsche914 Ordered a 2-port fuel pump to replace my failing 3... Apr 2 2012, 12:29 PM pcar916 Installed a bunch of 914Rubber, sprayed off about ... Apr 2 2012, 01:12 PM slothness Rebuilt 901 last week, locked out first per Dr. Ev... Apr 3 2012, 03:15 PM Eric_Shea http://www.914world.com/bbs2/uploads_offsite/fbcdn... Apr 3 2012, 03:18 PM audio_file Played with my knob (thanks again Zach), screwed a... Apr 3 2012, 03:22 PM sixnotfour Made a dog tag Apr 6 2012, 03:50 AM unpolire Yesterday I was at a guy's shop who has been w... Apr 6 2012, 04:03 AM Tom Worked on the second generation of my starter rela... Apr 6 2012, 10:42 AM effutuo101 nice! Apr 6 2012, 01:20 PM 2xs performance Fixed the hinge and reinstall the rear trunk lid. ... Apr 7 2012, 04:58 PM kconway Filled up with gear oil and removed the 30mm scave... Apr 7 2012, 05:44 PM Philip W. Pulled the transmission , taking it to the rebuild... Apr 7 2012, 07:53 PM euro911 Pulled the transmission , taking it to the rebuild... Apr 12 2012, 06:18 PM 914-300Hemi Added a external oil cooler today and no leaks. No... Apr 7 2012, 09:03 PM hot_shoe914 http://www.914world.com/bbs2/index.php?sho...75292... Apr 7 2012, 10:07 PM 914_teener
http://www.914world.com/bbs2/index.php?sho...7529... Apr 7 2012, 10:09 PM computers4kids Absolutely gorgeous today in Cali...sooo, decided ... Apr 7 2012, 10:39 PM Elliot Cannon
Absolutely gorgeous today in Cali...sooo, decided... Apr 7 2012, 11:31 PM oldschool Man its been about a month (been out of town) took... Apr 8 2012, 01:17 AM matthepcat Almost done with interior.
One last center tunnel... Apr 8 2012, 06:34 PM Ian Stott Took my bumper off so I could get the front valenc... Apr 8 2012, 07:00 PM mrbubblehead just finishing up the test mule. hopefully i will ... Apr 12 2012, 02:27 PM euro911 just finishing up the test mule. hopefully i will ... Apr 12 2012, 03:31 PM KaptKaos
[quote name='mrbubblehead' post='1665227' date='A... Apr 14 2012, 04:31 PM jsayre914 Took the shifter linkage off and beat the hell out... Apr 12 2012, 02:55 PM mrbubblehead looks like your going to do do some tuning mark...... Apr 12 2012, 03:47 PM poorsche914 Fuel pump finally arrived yesterday so I installed... Apr 12 2012, 04:26 PM 3d914
Fuel pump finally arrived yesterday so I installe... Apr 14 2012, 06:49 PM mrbubblehead YAHOO! my cylinder head temp instrument showed... Apr 13 2012, 05:07 PM effutuo101 I eyeballed my dash and decided a glove box rework... Apr 13 2012, 06:17 PM dinomium wrestling with the gas tank trying to replace the ... Apr 14 2012, 02:50 PM 914itis Gorgeous weather on thew east cost, drove it 20 mi... Apr 14 2012, 04:09 PM type47 did a brake fluid flush, filled up the tires, fill... Apr 14 2012, 04:43 PM brant
I did a big thing for the 914's awhile ago; I... Apr 14 2012, 05:18 PM type47
I did a big thing for the 914's awhile ago; ... Apr 15 2012, 05:34 AM brant
[quote name='brant' post='1666455' date='Apr 14 2... Apr 15 2012, 08:49 AM mrbubblehead
did a brake fluid flush, filled up the tires, fil... Apr 14 2012, 05:41 PM RON S. Me and the wife put 150 miles :muebaAX: on the ro... Apr 14 2012, 04:49 PM BIGKAT_83 My SBC 914 has been in storage for 18 months. Pull... Apr 14 2012, 05:15 PM 6freak watch out for ...Codes...cant run power in conduit... Apr 14 2012, 06:00 PM mrbubblehead
watch out for ...Codes...cant run power in condui... Apr 14 2012, 06:05 PM euro911 watch out for ...Codes...cant run power in conduit... Apr 14 2012, 08:11 PM 3d914 Got my engine on the test-run cradle. See link for... Apr 14 2012, 06:52 PM mrbubblehead busy day. i made and installed all of my thermocou... Apr 14 2012, 07:20 PM Philip W. Great day spent at Scotty's rebuilding transmi... Apr 14 2012, 08:07 PM brant mark
how do you connect the pvc to stub ups?
is ... Apr 14 2012, 08:25 PM euro911 mark
how do you connect the pvc to stub ups?Hey B... Apr 14 2012, 11:50 PM brant
mark
how do you connect the pvc to stub ups?Hey ... Apr 15 2012, 08:43 AM kg6dxn :D
2Ag1lXenmUk? Apr 14 2012, 08:42 PM mrholland2 I installed a new shifter knob. Excitement. Apr 14 2012, 09:07 PM JRust Started parting out the wrecked 74 I picked up a w... Apr 15 2012, 12:06 AM hot_shoe914 Finished the rust repair and metal work on the Ice... Apr 15 2012, 01:25 AM somd914 Ditto on Doc Evil's Richmond tranny clinic. I... Apr 15 2012, 09:33 AM  |
4 User(s) are reading this topic (4 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 29th June 2026 - 05:41 AM |
Invision Power Board
v9.1.4 © 2026 IPS, Inc.