 930 (108mm) output flange identification, Two pair with different seal landing dimensions |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| pcar916 |
 Apr 9 2012, 04:45 PM
Post
#1
|
|
Is that a Lola?  Group: Members Posts: 1,523 Joined: 2-June 05 From: Little Rock, AR Member No.: 4,188 Region Association: None 
 |
Anyone know these two 108mm applications?
 Both (on the right) are 108mm course-spline flanges. But as the pic below shows, the center flange has the same dimensions as the 914 flange (left) on all turned surfaces. The 108 flange on the right is the same dimensions (on turned surfaces) as the 100mm SC flanges I use with 944 cv's on my 914. I can just barely make out what I think may be the part number on the rightmost flange. 915.332.209/01 but this may be incorrect. It's not very distinct. Anyone run into both at some point? My guess is that the flange on the right is from the SC era and the center one is an earlier turbo, but I'm basing that on the SC dimension match, not from actual fact. Ideas? |
   |
 
|
Posts in this topic
pcar916 930 (108mm) output flange identification Apr 9 2012, 04:45 PM
Eric_Shea They did away with coarse splined flanges after 76... Apr 9 2012, 06:18 PM
Aaron Cox
Check Sporto vs, Standard...
I thought sporto... Apr 10 2012, 08:17 AM pcar916
I thought sporto's were 923 part number.....
... Apr 10 2012, 09:51 AM pcar916 I'll look into that. I didn't think of th... Apr 9 2012, 07:13 PM stewteral
Anyone know these two 108mm applications?
Both... Apr 9 2012, 10:59 PM pcar916 I'm still running the 914 trans and a GT LSD/1... Apr 10 2012, 07:45 AM stewteral
I'm still running the 914 trans and a GT LSD/... Apr 15 2012, 12:04 PM pcar916 Question answered by GT's Matt Monson. The lon... Apr 10 2012, 05:45 PM pcar916 It seems ultimately a wash in strength overall, bu... Apr 15 2012, 01:42 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 17th May 2024 - 05:58 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.