 Master Cylinder Grommet installation help |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| tornik550 |
 Oct 2 2012, 10:51 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,248 Joined: 29-January 07 From: Ohio Member No.: 7,486 Region Association: None  |
My master cylinder grommets have a slight leak. They are cracked and old. I purchased some new grommets. I removed the old ones already and did not pay attention to how they were installed. Which side of the grommet goes into the master cylinder- the wide side or the narrow side? Also, when I install the lines from the reservoir, do I push them all the way through the grommet so the line is pushing against the washer in the master cylinder or does the line rest in the bore of the grommet?
Attached image(s) 
|
   |
 
|
Posts in this topic
tornik550 Master Cylinder Grommet installation help Oct 2 2012, 10:51 AM
pilothyer The wide end goes in first, on top of the washers,... Oct 2 2012, 10:58 AM pilothyer Here is another link about this procedure:
ht... Oct 2 2012, 11:02 AM mepstein Looks like an easy job but it's not. Patience ... Oct 2 2012, 11:33 AM
infraredcalvin
Looks like an easy job but it's not. Patience... Oct 2 2012, 11:23 PM URY914 The picture above is unside down from the correct ... Oct 2 2012, 12:14 PM cwpeden I had to loosen of the master cylinder to get the ... Oct 2 2012, 11:28 PM euro911 ... and wipe off any brake fluid that gets on the ... Oct 3 2012, 12:44 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 20th May 2024 - 03:26 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.