 225's in front?, ayup |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| J P Stein |
 Jan 19 2003, 07:34 PM
Post
#1
|
|
Irrelevant old fart  Group: Members Posts: 8,797 Joined: 30-December 02 From: Vancouver, WA Member No.: 45 Region Association: None  |
A trial fit of 225 X 50 X 15 on 7s.
This is at the approximate ride height I'm going to have |
   |
 
|
  |
Replies
| J P Stein |
Jan 19 2003, 10:05 PM
Post
#2
|
|
Irrelevant old fart Group: Members Posts: 8,797 Joined: 30-December 02 From: Vancouver, WA Member No.: 45 Region Association: None |
Good question.
I had to go out and hook up a tie rod and find out. At normal ride height, it doesn't rub anywhere. There appears to be clearance on the inside for compression. My 205s did rub a bit, tho on the other side of the car and at full lock. Didn't bother me at all while driving. At full compression, who knows. I can't hardly turn the tire then as it rubs on the outside fender. I've got the bump stops set to provide 2 inches of compression below normal ride height. Comments? |
|
|
|
Posts in this topic
J P Stein 225's in front? Jan 19 2003, 07:34 PM
Van914 J.P.,
Nice lift with casters too! :beer1: Jan 19 2003, 07:38 PM J P Stein this is with the suspension on the bump stops........ Jan 19 2003, 07:38 PM Brad Roberts Yeah, but can you turn it lock to lock without tou... Jan 19 2003, 09:08 PM Jeroen "Yeah, but can you turn it lock to lock without to... Jan 19 2003, 09:35 PM Brad Roberts Here is my take on Negative camber: You are only g... Jan 19 2003, 09:58 PM Tony C The old Kumho's (victo-racers) on a 914/mid en... Jan 19 2003, 10:32 PM J P Stein The car is being set up for a fast guy, not me. I... Jan 19 2003, 10:32 PM Mueller JP,
I was running 225/50/16's on 8" wide Phon... Jan 20 2003, 11:04 AM J P Stein Since I'm droping the ride height a bit, I... Jan 20 2003, 11:49 AM
Dave_Darling QUOTE
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 16th May 2024 - 09:38 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.