 I'm a stud, Repair guy, hopefully |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
  |
| saigon71 |
 May 3 2013, 05:01 PM
Post
#21
|
|
Advanced Member  Group: Members Posts: 2,000 Joined: 1-June 09 From: Dillsburg, PA Member No.: 10,428 Region Association: MidAtlantic Region 
 |
|
   |
 
|
| Porschef |
May 3 2013, 10:37 PM
Post
#22
|
|
How you doin' Group: Members Posts: 2,165 Joined: 7-September 10 From: LawnGuyland Member No.: 12,152 Region Association: North East States
|
Rich, yes, there's a loctite type material on the insert. Once it heats it's supposed to stay put. I tapped out the hole just deep enough to accept the inserts depth, then tightened it a bit more..
Stu, I'm not sure; do you mean to remove the existing installed studs? I don't know about heating them; others surely know better. Could be as simple as a vice grip, or at least double nutting. Thanks Bob. |
|
|
|
| stugray |
May 4 2013, 02:05 PM
Post
#23
|
|
Advanced Member Group: Members Posts: 3,825 Joined: 17-September 09 From: Longmont, CO Member No.: 10,819 Region Association: None |
QUOTE I forgot to take a pic of the stud in the insert. wacko.gif I picked it up at the local Ace hardware. Thanks for the tip! I posted a thread about where to find exhaust studs just a week or so ago. I searched at Ace better and found them! 8X1.25 X 62 mm. Just a tad long but that is fine. I also found two different types of stud extractors just like the pic posted at Sears. Well see how it goes tonight. Stu |
|
|
|
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 7th June 2024 - 09:18 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.