 Engine tin question, is this normal? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| gklinger |
 Jan 1 2005, 10:59 AM
Post
#1
|
|
doh!  Group: Members Posts: 316 Joined: 14-January 03 From: Tempe, AZ Member No.: 146 Region Association: Southwest Region  |
I am the proud owner of an A/C car (IMG:http://www.914world.com/bbs2/html/emoticons/wacko.gif), and am working to undo the hack job done many years ago. I have picked up replacement tin over time, but never having seen a complete unmolested set, I'm not sure what I've got is correct. The tin that goes in the front of the motor, on the right side sorta flips up at the end on both of the replacements that I've acquired. Is this right? Looking at the shelf in the car, it looks like this should follow the nice smooth curve from left to right and so should turn down somewhat, but if I were to try to make this conform, it would definitely kink the tin at the front lip where it bends over and down. Both pieces that I've got are the same. Can anyone offer any advice?
Attached image(s) 
|
   |
 
|
Posts in this topic
gklinger Engine tin question Jan 1 2005, 10:59 AM
gklinger closer Jan 1 2005, 10:59 AM
vsg914 I too have one that is bent like that, but the oth... Jan 1 2005, 11:45 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 16th May 2024 - 02:14 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.