 new engine bay rubber seal i,now have gap |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| rosenfe |
 Feb 2 2014, 11:40 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 553 Joined: 14-October 13 From: northern california Member No.: 16,512 Region Association: None  |
i put new seasl from 914 rubber.com,put engine back in and there is a gap between tin and rubber on passenger side.not sure why.i installed rubber with j part down and folding up towards enginekinda ok on drivers side ,some gap there too.bad rubber,wrong install.?,back of engine ok.
|
   |
 
|
Posts in this topic
rosenfe new engine bay rubber seal i,now have gap Feb 2 2014, 11:40 PM
euro911 Got pix ???
The 'J' should reach under an... Feb 2 2014, 11:47 PM bdstone914 A picture might help. How does the engine tin to e... Feb 2 2014, 11:51 PM Mikey914 Post a pic, I'm sure I can help. Not sure why ... Feb 3 2014, 12:45 AM euro911 That's what I was thinking, Mark. I've see... Feb 3 2014, 12:56 AM Mikey914 I have even seen guys staple the corners, but that... Feb 3 2014, 01:38 AM
rosenfe
I have even seen guys staple the corners, but tha... Feb 3 2014, 10:26 AM rosenfe
I have even seen guys staple the corners, but th... Feb 3 2014, 10:27 AM rosenfe
[quote name='rosenfe' post='1992615' date='Feb 3 ... Feb 3 2014, 10:28 AM Mikey914 The mounts for the engine will not have much ... Feb 3 2014, 11:40 AM rosenfe
The mounts for the engine will not have much ... Feb 3 2014, 11:54 AM kkid Wondering if your engine tin got bent up/down upon... Feb 3 2014, 11:57 AM Mikey914 True if you put it up in the hole and catch an edg... Feb 3 2014, 12:15 PM rosenfe
True if you put it up in the hole and catch an ed... Feb 3 2014, 12:39 PM stugray I actually have the same problem but Ive forgotten... Feb 3 2014, 06:19 PM euro911 Post some pix of your mount, Stu Feb 3 2014, 06:50 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 28th May 2024 - 12:02 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.