Home  |  Forums  |  914 Info  |  Blogs
 
914World.com - The fastest growing online 914 community!
 
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.
 

Welcome Guest ( Log In | Register )

 
Reply to this topicStart new topic
> Flip up headlight gaps
57lincolnman
post May 19 2014, 10:01 PM
Post #1


Member
**

Group: Members
Posts: 174
Joined: 14-September 10
From: Los Angeles
Member No.: 12,175
Region Association: Southern California



Is it possible to adjust the gaps around the flip up painted metal headlight covers? In particular, I'd like to if the gap at the rear edge (away from bumper) where it meets the front trunk lid has an adjustment. Are there adjusting screws somewhere? The passenger side has a bigger gap than on the driver's side. I'm trying to even them out.
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
McMark
post May 19 2014, 10:06 PM
Post #2


914 Freak!
***************

Group: Retired Admin
Posts: 20,179
Joined: 13-March 03
From: Grand Rapids, MI
Member No.: 419
Region Association: None



You adjust the whole headlight assembly. Three bolts inside the trunk, two bolts in the fender.
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
Mblizzard
post May 21 2014, 12:36 PM
Post #3


Advanced Member
****

Group: Members
Posts: 3,033
Joined: 28-January 13
From: Knoxville Tn
Member No.: 15,438
Region Association: South East States



I thought there was a way to set them using the knob on the motor? Of course I tried and it did not work. I could have sworn I did it that way in the past but that was many beers ago.
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
bdstone914
post May 21 2014, 12:47 PM
Post #4


bdstone914
****

Group: Members
Posts: 4,876
Joined: 8-November 03
From: Riverside CA
Member No.: 1,319



QUOTE(Mblizzard @ May 21 2014, 11:36 AM) *

I thought there was a way to set them using the knob on the motor? Of course I tried and it did not work. I could have sworn I did it that way in the past but that was many beers ago.


The knob is just to raise them manually.
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



- Lo-Fi Version Time is now: 21st April 2025 - 05:42 AM