 Valve adjustment problem w/hydraulic lifters |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| rjames |
 Oct 25 2014, 05:09 PM
Post
#1
|
|
I'm made of metal  Group: Members Posts: 3,933 Joined: 24-July 05 From: Shoreline, WA Member No.: 4,467 Region Association: Pacific Northwest 
 |
Verifying valves are set properly and I can't adjust one of the exhaust valves past zero lash without tremendous effort. The associated pushrod doesn't budge. None of the others are that way. Do I need to pull the lifter or is there a chance I can run it at zero lash for a few minutes and try adjusting it again without hurting anything?
|
   |
 
|
  |
Replies
| Katmanken |
Oct 26 2014, 08:39 PM
Post
#2
|
|
You haven't seen me if anybody asks... Group: Members Posts: 4,738 Joined: 14-June 03 From: USA Member No.: 819 Region Association: Upper MidWest |
Sometimes you can pull them out with one of those magnets on a stick.
|
|
|
|
Posts in this topic
rjames Valve adjustment problem w/hydraulic lifters Oct 25 2014, 05:09 PM
messix I would pull the lifter and soak it in oil for a w... Oct 25 2014, 05:14 PM
Drums66
I would pull the lifter and soak it in oil for a ... Oct 26 2014, 12:27 PM Cap'n Krusty There is a known bleed problem with some of the Fe... Oct 25 2014, 06:48 PM rjames So don't run the engine, and remove the lifter... Oct 25 2014, 07:35 PM messix yes , remove rocker assembly. remove push rod tube... Oct 25 2014, 09:22 PM rjames
yes , remove rocker assembly. remove push rod tub... Oct 25 2014, 09:37 PM type47 I think add this step
yes , bring cylinder to TDC... Oct 26 2014, 06:24 AM rjames Put it at TDC for #3 as instructed. (Exhaust #3 is... Oct 26 2014, 05:24 PM messix remove rockers, remover push rod tube, you should ... Oct 26 2014, 05:46 PM rjames Ok, I got the #3 rocker off and pushrod out easily... Oct 27 2014, 12:28 AM Nate No. You actually don't need to remove the rock... Oct 27 2014, 02:16 PM rjames
No. You actually don't need to remove the roc... Oct 27 2014, 04:22 PM rjames Double post Oct 27 2014, 11:45 PM rjames For Fuchs sake. 2 hours trying to remove a damned ... Oct 27 2014, 11:46 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 19th May 2024 - 11:57 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.