 Front trunk springs length open & closed, Close assist gas spring upgrade |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Harpo |
 Jan 23 2015, 08:18 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,304 Joined: 21-August 11 From: Motor City aka Detroit Member No.: 13,469 Region Association: None  |
I would like to replace my front trunk springs with gas shocks. The problem is most gas shocks the relaxed state is open. However to replace the spring with out changing the design requires a gas shock that is closed in the relaxed state
This is where I need some help from my fellow 914world members I need the measurements of the spring on the car with the hood open & closed. The delta of these will allow me to order the right spring. My car is in pieces and getting ready for paint Thanks David |
   |
 
|
  |
Replies
| jim_hoyland |
Jan 27 2015, 10:27 PM
Post
#2
|
|
Get that VIN ? Group: Members Posts: 9,291 Joined: 1-May 03 From: Sunset Beach, CA Member No.: 643 Region Association: Southern California 
|
Are you making these different from the Camp 914 model ?
|
|
|
|
Posts in this topic
Harpo Front trunk springs length open & closed Jan 23 2015, 08:18 AM
Dave_Darling The easy way is to remove the springs, and use the... Jan 23 2015, 11:03 AM
Kansas 914
The easy way is to remove the springs, and use th... Jan 23 2015, 12:26 PM JmuRiz Mine bent the spring tabs...I'm going back to ... Jan 23 2015, 01:50 PM 76-914
Mine bent the spring tabs...I'm going back to... Jan 23 2015, 04:10 PM Harpo I'm using the camp914 set up on my rear but I ... Jan 23 2015, 03:37 PM SirAndy I did mine before the kit from Camp914 was availab... Jan 23 2015, 04:33 PM SirAndy I used 911 engine lid shocks Jan 24 2015, 02:44 PM McMark But still, can someone measure for him? I can do i... Jan 23 2015, 10:42 PM Harpo There is 2.5 inches of travel with the factory spr... Jan 24 2015, 02:35 PM Mike Bellis
There is 2.5 inches of travel with the factory sp... Jan 24 2015, 03:31 PM Harpo Yea, got to find a cheaper option Jan 24 2015, 04:14 PM Larry Hubby McMaster stuff can be spendy. Try Orr and Orr in ... Jan 24 2015, 07:36 PM Mike Bellis
McMaster stuff can be spendy. Try Orr and Orr in... Jan 27 2015, 10:32 PM McMark I got some rough measurements. Close enough for t... Jan 26 2015, 10:26 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 15th May 2024 - 06:31 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.