 Correct door gap between rear fender and the door. |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| jkb944t |
 May 21 2015, 05:31 AM
Post
#1
|
|
Member  Group: Members Posts: 464 Joined: 17-January 05 From: Canton, OH Member No.: 3,459 Region Association: None  |
I am in the process of replacing the section of fender shown below.
 I am trying to line up the new fender section with the door correctly but I am not sure how to set the gap. What is the correct gap and will it be the same from the top of the door gap to the bottom. The gap seems to want to vary from about .185 at the top of the door to about .210 at the bottom.  I could use some good input on how best to align this fender section and what is the correct gap before I weld it in place and tie it into the fender flare. Jeff B |
   |
 
|
  |
Replies
| Downunderman |
May 24 2015, 02:29 AM
Post
#2
|
|
Senior Member Group: Members Posts: 852 Joined: 31-May 03 From: Sydney, Australia Member No.: 766 Region Association: Australia and New Zealand |
So much simpler in metric. Been that way down here since 1976.
|
|
|
|
Posts in this topic
jkb944t Correct door gap between rear fender and the door. May 21 2015, 05:31 AM
cary What have you done to the car? May 21 2015, 06:55 AM Kansas 914
I could use some good input on how best to align... May 21 2015, 08:06 AM jkb944t I probably should have clarified that I had alread... May 21 2015, 10:30 AM cary 5 mm May 23 2015, 08:38 PM jkb944t Thanks, 5mm seems reasonable based on what I am se... May 24 2015, 07:16 AM stevegm The thickness of 2 1/2 dimes laid flat. 2 is to li... May 24 2015, 07:30 AM cary Here's what I'm doing.
May 24 2015, 07:30 AM
rgalla9146 Please don't do this job with the car on the r... May 24 2015, 09:46 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 19th May 2024 - 05:28 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.