 Two questions: Driveshafts and switched +12v, before or after engine goes back in? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| falcor75 |
 Jun 20 2015, 12:00 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,579 Joined: 22-November 12 From: Sweden Member No.: 15,176 Region Association: Scandinavia 
 |
So I'm getting ready to put my engine and gearbox back in after two years. I remember getting it out was a little tricky due to the driveshafts. Do they need to go back in before the engine?
Question two: Is there any place on the engine bay relay board that's suitable to pull an extra switched +12v out to my new ecu? |
   |
 
|
Posts in this topic
falcor75 Two questions: Driveshafts and switched +12v Jun 20 2015, 12:00 AM
914Sixer Put the drive shafts in after the engine/transmiss... Jun 20 2015, 07:26 AM SLITS I will strongly disagree .... put the CVs in prior... Jun 20 2015, 07:50 AM PanelBilly Shafts in first. Then engine. Jun 20 2015, 09:08 AM michael7810 Agree to put the driveshafts in before the engine/... Jun 20 2015, 09:44 AM falcor75 My engine is just the engine and trans, no exhaust... Jun 20 2015, 10:25 AM Dave_Darling It's not that hard to work the drivetrain in a... Jun 20 2015, 11:09 AM
Dtjaden On the relay board in the lower left hand corner i... Jun 20 2015, 06:13 PM falcor75
On the relay board in the lower left hand corner ... Jun 21 2015, 12:16 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 8th December 2025 - 03:54 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.