 What to cut?, Sawzall party |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Seventyfive914 |
 Feb 23 2005, 10:48 PM
Post
#1
|
|
Member  Group: Members Posts: 72 Joined: 9-December 04 From: Wilmington, NC Member No.: 3,249  |
Hello. Well I'm progressing slowly to the point where it's getting to be time to put the "little white car" on a diet care of the cut off wheel and the whole saw. My first question is, in the rear trunk where the stock engine lid latch is located, is it ok to remove that section of sheet metal that is bent 45 degrees out beyond the strut towers? Looks to me like it does not contribute to the structural integrity of the tub, and the removal of it would obviously save some weight as well as provide better access to the engine. I'd just like some knowlegable advice before I get all medieval with the cutting implements. Thanks, -K-
|
   |
 
|
Posts in this topic
Seventyfive914 What to cut? Feb 23 2005, 10:48 PM
Lawrence That's a tough question. What are you trying ... Feb 23 2005, 11:06 PM bryanthompson Are you gonna sell off the metal? If so, can I ca... Feb 23 2005, 11:22 PM Jeroen The engine/rear trunk firewall provides a great de... Feb 24 2005, 07:12 AM
Seventyfive914 Thanks for the feedback gentlemen. Lawrence, yes m... Feb 24 2005, 10:09 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 17th May 2024 - 10:12 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.