 Stripped oil drain plug |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| smj |
 Sep 3 2015, 01:21 PM
Post
#1
|
|
"Dude, Steve from Berkeley."  Group: Members Posts: 591 Joined: 28-August 05 From: Berkeley, CA Member No.: 4,691 Region Association: Northern California 
 |
Bringing the 914-4 back from mostly sitting for the past three years (under 1,000 miles in all that time), I forgot the oil drain plug was boogered up by a DAPO or oil change place...
Based on what came out, there were only a few shreds of thread somehow attached to the bottom of the drain plug hole, and a horribly mangled soft crush washer. Most of the "bore" is pretty smooth, with some original thread left at the top. Pic below. My question is how to fix this. I see references to Heli-Coils, but somewhere I got the impression they need some thread left...? Whereas a Time-Sert or similar requires boring and fitting a thread insert. How difficult is it to do this right with something like a Time-sert for a guy that reassembled some CV joints correctly on the *second* try? With the car up on jack stands in the back, so at an angle. And then what the heck do I use for a drain plug? Thanks!  |
   |
 
|
Posts in this topic
smj Stripped oil drain plug Sep 3 2015, 01:21 PM
Jeff Bowlsby How about using an oversized drain plug from FLAPS... Sep 3 2015, 01:30 PM
RobW
How about using an oversized drain plug from FLAP... Sep 3 2015, 02:15 PM smj Really, self-tapping oil drain plugs? I honestly h... Sep 3 2015, 01:37 PM 914Mels If you can find a larger size drain plug from anot... Sep 3 2015, 02:42 PM yeahmag Time-serts are dead simple to use and a very nice ... Sep 3 2015, 03:29 PM Sleepin I used a time-sert on my 1.8 and never had an issu... Sep 3 2015, 03:44 PM smj I notice that Time-Sert goes up to 24mm. So I reck... Sep 3 2015, 04:48 PM Series9 Clean it thoroughly, take it to a welder, weld it ... Sep 3 2015, 06:15 PM porschetub
Clean it thoroughly, take it to a welder, weld it... Sep 3 2015, 08:31 PM BobMC914 As a cheap-ass, I would say tap it for pipe thread... Sep 3 2015, 06:58 PM Mark Henry I did the pipe plug on my dads vanagon, it worked ... Sep 3 2015, 08:21 PM smj BTW thanks to everybody for your replies, I really... Sep 3 2015, 08:54 PM Mueller I swear I have not been drinking tonight!
Cra... Sep 3 2015, 10:35 PM mbseto I would think any regular bolt would work with a g... Sep 4 2015, 08:00 AM smj It was a bit of a pain finding a big enough tap wr... Sep 7 2015, 10:47 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 18th May 2024 - 11:46 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.