 Waterlogged core engine, Engige underwater |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| CatDaddy60 |
 Nov 25 2015, 10:02 PM
Post
#1
|
|
Member  Group: Members Posts: 99 Joined: 30-January 13 From: Austin Tx Member No.: 15,451 Region Association: Southwest Region  |
I picked up a core engine from a junk yard and while I was doing enough of a teardown so that I could get it out of my truck I put a wrench on the alternator bolt to see if the engine would roll over. To my surprise the engine rolls over. Have any of you had experience with aan type 4 that's been underwater?
|
   |
 
|
  |
Replies
| brant |
Nov 26 2015, 01:04 AM
Post
#2
|
|
914 Wizard Group: Members Posts: 11,623 Joined: 30-December 02 From: Colorado Member No.: 47 Region Association: Rocky Mountains 
|
Don't let it sit too long. It will freeze up and do damage eventually. Tear it open, how long since its been out of the water?
|
 |
|
| CatDaddy60 |
Nov 26 2015, 04:23 AM
Post
#3
|
|
Member Group: Members Posts: 99 Joined: 30-January 13 From: Austin Tx Member No.: 15,451 Region Association: Southwest Region |
QUOTE(brant @ Nov 25 2015, 11:04 PM)  Don't let it sit too long. It will freeze up and do damage eventually. Tear it open, how long since its been out of the water? That will be the million dollar question there was quite a bit of water that came out of the cyl enough that they had to have been almost if not full. there is some evidence of water being in the intake tract , rusty water, so a tear down is in the immediate future for sure. I'll try to post some pictures of the carnage. |
|
|
|
Posts in this topic
CatDaddy60 Waterlogged core engine Nov 25 2015, 10:02 PM
colingreene I would say its completely trashed. Nov 26 2015, 12:12 AM
thelogo
I would say its completely trashed.
2nd that
... Nov 29 2015, 07:33 PM RobW
I would say its completely trashed.
2nd that ... Nov 30 2015, 01:43 PM Mikey914 Bearings are most likely done, tear it down. see w... Nov 26 2015, 12:34 AM RobW I had an engine that took in water. I even started... Nov 26 2015, 07:25 AM CatDaddy60
I had an engine that took in water. I even starte... Nov 26 2015, 11:35 AM RobW
I had an engine that took in water. I even start... Nov 27 2015, 08:17 AM r_towle Rust does not happen as much under water.
Now that... Nov 26 2015, 10:00 AM r_towle My son flooded the boat a few years ago.
It had ov... Nov 27 2015, 10:58 AM Spoke I bought a 1.8L engine a while back with carbs. Th... Nov 29 2015, 08:35 AM DBCooper Same experience several times, cleaned and ran the... Nov 29 2015, 09:13 AM CatDaddy60 After a teardown due to leaves and evidence of dir... Nov 29 2015, 06:12 PM CatDaddy60 Photos Nov 29 2015, 06:28 PM mbseto
My son flooded the boat a few years ago.
It had o... Nov 30 2015, 09:15 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 14th May 2024 - 06:38 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.