 Waterlogged core engine, Engige underwater |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| CatDaddy60 |
 Nov 25 2015, 10:02 PM
Post
#1
|
|
Member  Group: Members Posts: 99 Joined: 30-January 13 From: Austin Tx Member No.: 15,451 Region Association: Southwest Region  |
I picked up a core engine from a junk yard and while I was doing enough of a teardown so that I could get it out of my truck I put a wrench on the alternator bolt to see if the engine would roll over. To my surprise the engine rolls over. Have any of you had experience with aan type 4 that's been underwater?
|
   |
 
|
  |
Replies
| CatDaddy60 |
Nov 29 2015, 06:12 PM
Post
#2
|
|
Member Group: Members Posts: 99 Joined: 30-January 13 From: Austin Tx Member No.: 15,451 Region Association: Southwest Region |
After a teardown due to leaves and evidence of dirt and silt down the oil fill area I found a crack and a disintegrating cylinder in number 3 jug the crack ran the entire length of the cylinder and the is a chunk missing from the top of the cylinder. It looks like it went out of the cylinder past the valves but without cleaning up the head I can't see if the seat is OK. The rod bearings are not bad other than wear the crank journals will clean up but no rust just need cleaning cam same thing.
|
|
|
|
Posts in this topic
CatDaddy60 Waterlogged core engine Nov 25 2015, 10:02 PM
colingreene I would say its completely trashed. Nov 26 2015, 12:12 AM
thelogo
I would say its completely trashed.
2nd that
... Nov 29 2015, 07:33 PM RobW
I would say its completely trashed.
2nd that ... Nov 30 2015, 01:43 PM Mikey914 Bearings are most likely done, tear it down. see w... Nov 26 2015, 12:34 AM brant Don't let it sit too long. It will freeze up ... Nov 26 2015, 01:04 AM CatDaddy60
Don't let it sit too long. It will freeze up... Nov 26 2015, 04:23 AM RobW I had an engine that took in water. I even started... Nov 26 2015, 07:25 AM CatDaddy60
I had an engine that took in water. I even starte... Nov 26 2015, 11:35 AM RobW
I had an engine that took in water. I even start... Nov 27 2015, 08:17 AM r_towle Rust does not happen as much under water.
Now that... Nov 26 2015, 10:00 AM r_towle My son flooded the boat a few years ago.
It had ov... Nov 27 2015, 10:58 AM Spoke I bought a 1.8L engine a while back with carbs. Th... Nov 29 2015, 08:35 AM DBCooper Same experience several times, cleaned and ran the... Nov 29 2015, 09:13 AM CatDaddy60 Photos Nov 29 2015, 06:28 PM mbseto
My son flooded the boat a few years ago.
It had o... Nov 30 2015, 09:15 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 14th May 2024 - 03:14 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.